Run the ipv6 enable command in the IS-IS view to enable the IPv6 capability of an IS-IS process. On each interface that needs to run an IS-IS process, run the ipv6 enable command to enable the IPv6 capability and configure an IPv6 address. Run the isis ipv6 enable command to enab...
The ipv6 enable command enables the IPv6 function on an interface. The undo ipv6 enable command disables the IPv6 function on an interface. By default, the IPv6 function is disabled on an interface. Format ipv6 enable undo ipv6 enable Parameters None Views Interface view Default Level 2...
To configure an IPv6 address based on an IPv6 general prefix and enable IPv6 processing on an interface, use the ipv6 address command in interface configuration mode. To remove the address from the interface, use the no form of this command. ipv6 address {ipv6-prefix/prefix-length | pr...
To enable IPv6 multicast forwarding of packets received from a specific interface on the router, use the ipv6 mfib forwarding command in interface configuration mode. To disable IPv6 multicast forwarding of packets received from a specific interface, use the no form of this command. ipv6 mfib...
(一)使能口令(enable password),口令以明文显示 (二)使能密码 (enbale secret),口令以密文显示 两者一般只需要配置其中一个,如果两者同时配置时,只有使能密码生效. Switch.> /*用户直行模式提示符 Switch.>enable /*进入特权模式 Switch.# /*特权模式提示符 ...
To export IPv6 flow statistics, you must run the ipv6 netstream command to enable IPv6 flow statistics collection on the inbound interface. Precautions You can run the netstream ipv6 command and the netstream ip command on the same interface to collect statistics about IPv4 flows and IPv6 ...
To export IPv6 flow statistics, you must run the ipv6 netstream command to enable IPv6 flow statistics collection on the inbound interface. Precautions You can run the netstream ipv6 command and the netstream ip command on the same interface to collect statistics about IPv4 flows and IPv6 ...
Command qualified for use inCisco SD-WAN ManagerCLI templates. The following example enables the IPv6 Unique Local Address: Router(config)#systemRouter(config-system)#enable-ipv6-unique-local-address gps-location (system) To configure the location and the geofencing boundary for a dev...
Cisco Firepower 1150 Threat Defense 7.1.0 1558 MgmtIP: 127.128.254.1 MgmtIP: fd00:0:0:1::3 Capability: Bridge, on Capability: Router, off Capability: Wlan , off Capability: Station, off Port: PortID: mac 34:12:78:56:01:03 PortDescr: Ethernet1/6 TTL: 120 --- Related ...
Chapter: BGP Address-Family (IPv4/IPv6) Configuration Mode Commands The Border Gateway Protocol (BGP) Address-Family (IPv4/IPv6) Configuration Mode is used to configure the IPv4 and IPv6 address family information. Mode Exec > Global Configuration > Context Configuration > ...