We normally useServices.mscto start or stop or disable or enable any service. We can do the same from windows command line also usingnetandscutilities. Below are commands for controlling the operation of a service. Command to stop a service: net stop servicename To start a service: net st...
sc config lanmanworkstation start= demand In the above command you can use any of the options {boot, system, autoordemand} to enable the service. To disable the service you need to run the following command. sc config lanmanworkstation start= disabled To stop workstation service: net stop ...
Before configuring a service, enter the system view. After the system view is displayed, the system initiates the corresponding configuration process based on the configured mode. The immediate mode is the traditional mode. After you enter a command line and press Enter, the system performs the ...
Specifies whether to force a service to stop even if it has dependent services. Include Lets you include particular services. Services not matching one of these (if specified) are excluded. These are interpreted as either ServiceNames or DisplayNames according to the parameter set. (Inherited fr...
For example, we can “Start” a Service or “Stop” a Service. The command names for these operations are: “Start-Service” and “Stop-Service”. (Note the use of the “-” character to separate the verb and noun.)3.2 Verbs Commands must choose a verb from the list of standard ...
However, running certain commands may cause device faults or service interruptions. Therefore, use these diagnostic commands under the instruction of technical support personnel. Example # Enable a device to enter the diagnostic view. <HUAWEI> system-view [HUAWEI] diagnose [HUAWEI-diagnose] display ...
Use the stopLMService command to stop a started local mapping service. A local mapping service, when first created, is in the started state. A started local mapping service intercepts requests whether or not service map is attached. Target object The name of a local mapping service, as ...
PARAMETER file-spec specifies the path to the file to view. Run Commands run loadxml run sql run loadxml run cuic sql run loadxml This command can be run on the publisher (the Controller node) as a workaround whe...
A single PortQry command can use only one of these parameters. A query to UDP port 389 (LDAP) might not work against domain controllers that are running Windows Server 2008. To check the availability of the service that's running on UDP port 389, you can use Nltest instead of PortQry....
stop <service instance> Stops a specific service. refresh <service instance> Causes a service to refresh its configuration parameters. unload <service instance> Causes a service to be unloaded and removed. register <service name> Causes a service to be automatically loaded on the next device reboo...