01：中央对齐模式1 计数器交替地向上和向下计数。输出比较中断标志位，只在计数器向下计数时被设置 10：中央对齐模式2 计数器交替地向上和向下计数。输出比较中断标志位，只在计数器向上计数时被设置 11：中央对齐模式3 计数器交替地向上和向下计数。输出比较中断标志位，只在计数器向下和向上计数时均被...
TIM_CounterMode_CenterAligned1 中央对齐模式1。计数器交替地向上和向下计数。 产生下溢中断,配置为输出的通道(TIMx_CCMRx寄存器中CCxS=00)的输出比较中断标志位,只在计数器向下计数时被设置。 TIM_CounterMode_CenterAligned2 中央对齐模式2。计数器交替地向上和向下计数。 产生上溢中断,配置为输出的通道(TIMx_CC...
I am looking at Advanced-control timers (TIM1&TIM8) Center-aligned mode (up/down counting), I understand that this only works between 0 and TIMx_ARR but I can offset the waveform to the correct point From the manual page 297 I understand that “In center-al...
We are using a TC367 chip with 2.0 as the reference (configured with variable period and duty cycle) and 2.1,2.3,2.4 configured with 2.0 as the reference in center aligned mode (PWM_17_GTMCCU6_FIXED_PERIOD_CENTER_ALIGNED). Now I want to control the motor inverter, and I found that the...
2025-02-07 00:24:14 积分:1 acwing708-偶数 2025-02-06 18:07:03 积分:1 acwing665-倍数 2025-02-06 17:56:36 积分:1 VM 与 Device/Credential Guard 不兼容 2025-02-06 16:38:43 积分:1 经纬度计算日出日落(c语言) 2025-02-06 16:15:55 积分:1 Spring...
atomCh->CTRL.B.UDMODE = 1; /* enabling Up-Down-Counter-Mode, bitwise access to register */ /* Up/down counter mode Note: This mode is only applicable in SOMP mode. 00B Up/down counter mode disabled: CN0 counts always up 01B Up/down counter mode enabled: CN0 counts up and down,...
If you do use PLL, the source synchronous mode is meant to maintain data/clock relationship at pins right through to the registers. In other words it is meant for the case when PLL is not designed to rotate the clock. Translate 0 Kudos Copy link Reply All...
If you do use PLL, the source synchronous mode is meant to maintain data/clock relationship at pins right through to the registers. In other words it is meant for the case when PLL is not designed to rotate the clock. Translate 0 Kudos Copy link Reply All...