添加axis_data_fifo IP核,配置为packet mode模式,如下: 仿真代码实现功能为写入0 – 99共100个数据,如下: 配置为packet mode时,当slave端口中tlast有效后,master端口开始发送数据,波形如下: 当fifo中的数据存满时,也会触发master端口发送数据,设置的axis_data_fifo深度为512,写入515个数据,代码如下: 波形如下: ...
S_AXIS_tlast表示写入的最后一个数据,读取端同理,需要注意的是,S_AXIS_tkeep需要保持高电平。 读取端的控制信号同理。 参考资料:https://www.xilinx.com/support/documentation/ip_documentation/axis_interconnect/v1_1/pg035_axis_interconnect.pdf 以下是仿真代码 `timescale1 us / 1 psmoduledata_fifo_wrap...
1. The LIS3DH sensor block is placed in the downstream function-call subsystem. The output of the block is connected to MATLAB function block. The FIFO data acquired by the MATLAB function is averaged, and tilt of each axis is calculated. 2. Ensure that theGenerate data ready interrupt on...