If you create a mirrored ZFS root pool with the initial installation method, then this step is unnecessary. For more information about installing boot information, see Booting From an Alternate Disk in a Mirrored ZFS Root Pool.For more information about adding or attaching disks, see Managing ...
zpool replace -f rpool /dev/disk/by-id/ss1-part3 /dev/disk/by-id/ss2-part3## 提示错误 cannot offline /dev/disk/by-id/ss1-part3: no such device in pool## 因为坏硬盘在系统中完全无法识别导致路径失效,对此可以采用填写硬盘GUID的方式进行,## 使用 zdb 命令查看 损坏硬盘路径对应的GUID。zpoo...
also applies to lone disks, which is one way to replace it (make it a mirror, wait to sync, detach the old disk)ZFS always stripes across a pool's top-level vdevs.so analogues to most classical RAID variants exist as RAID0: all disks at top level RAID1: add a single mirror at...
root@erpband-pve1:~# zpool import -d /dev/disk/by-partlabel/ zp-erp1-hdd After a 3-5 minutes, the ARC size starts to grow. arc_summary | grep -E 'ARC size \(current\)|Min size \(hard limit\)|Max size \(high water\)|Anonymous metadata size' ARC size (current): 2616.7 % ...
使用以下命令确认efi启动正常。 proxmox-boot-tool refresh 参考文章: https://r00t.dk/post/2022/05/02/proxmox-ve-7-replace-zfs-boot-disk/ https://www.cnblogs.com/Levo8561/p/16013834.html 可以转载啊,随便转,不知道为什么b站的文章编辑不了这个选项了。
#运行zpool replace命令 这里由于硬盘识别id实在太长了就不打了,仅附上proxmox wiki(opens new window)中的两种对应的替换方案。 直接更换设备,如果热插拔使得新旧设备id相同,则可以直接省略“new device”。zpool replace -f 更换分区 sgdisk-Rsgdisk-Gzpool replace-fpve-efiboot-toolformatpve-efiboot-tool init...
System information Type Version/Name Distribution Name zpool is degraded, replace disk, auto repeat several times replace Distribution Version a Linux Kernel 3.10.0-1062.12.1 Architecture a ZFS Version 0.8.3-1 SPL Version 0.8.3-1 Describ...
Degraded Pool:If a pool is degraded, use thezpool statuscommand to identify the problematic disk. Replace the faulty disk withzpool replace. How to executeRAID consistency check. Failed Disk Replacement:When replacing a failed disk, ensure that the replacement disk is properly recognized by the sy...
For many years, our recommendation was to create a pool based on current capacity requirements and then grow the pool to meet increasing capacity needs by adding VDEVs or by replacing smaller LUNs with larger LUNs. It is trivial to add capacity or replace smaller LUNs with larger LUNs, someti...
Just replace<pool>,<device-part1>and<device-part2>with the pool name and the two/dev/disk/by-id/paths to the partitions. You can also add ZIL and cache separately. Add a log device to an existing ZFS pool # zpool add <pool> log <log-device> ...