SCU-19 USB Driver Software Installation Do not connect the transceiver to the computer via the SCU-19 PC Connection Cable until the driver installation process has been completed. Connecting the SCU-19 to the computer before installation has been completed may result in the wrong driver being ...
ClickHEREto download the Full line VHF/UHF catalog. ClickHEREto register your Yaesu Product Online. Yaesu USA in Cypress, CA is currently looking for an Amateur Technician for repair units. If you have experience and ability with Radio Amateur VHF and UHF mobile transceiver repair, and currently...
By adjusting the USB/LSB transmit from your factory setting to +1.530, you have basically placed the -6db point of your new filters close to +30Hz from dial frequency. I would not adjust the transmit carrier offset any closer than 1.520, as this will adjust your transmit band- pass such ...
6 SCU-20 USB Driver Software Installation Do not connect the transceiver to the computer via the SCU-20 PC Connection Cable until the driver installation process has been completed. Connecting the SCU-20 to the computer before installation has been completed may result in the wrong driver being ...
6 Before using the ADMS-8 FT2DR/DE Programmer When using the optional SCU-19 PC USB connection cable, or the SCU-16 USB serial adaptation cable, be sure to install the designated driver before connecting either cable to the computer. Select the communication port that is connected to the ...
(32 bit/64 bit, Service Pack 1 or later) CablesNecessary PC peripheral interfaces USB interface (USB Port) or Serial Port (RS-232C) Cables PC connection cable SCU-20 or Data cable CT-163 or CT-165 * When using the SCU-20 PC connection cable, install the designated driver on the ...
4. Connect the SCU-35 Programming Cable to the USB jack on the computer. • The SCU-35 Programming Cable will be recognized automatically. • Confirm that the SCU-35 driver is installed correctly, If the driver fails, proceed to “When the Driver Software Installation Fails” on the ...
the SCU-19 or CT-169 PC connection cable together with the SCU-16 USB serial conversion cable may be used to connect the FT1XDR/XDE/DR/DE to the computer to edit the information. The programming can be performed comfortably on the large screen of a computer: S Edit the frequencies, memo...
Click the [Next], to initiate the installation of the driver. 3. When the installation is finished, the dialog box shown right will open. Click the [Finish], to complete the installation of the driver. 4. Connect the SCU-35 Programming Cable to the USB jack on the computer. • The ...