可以选择把数据输出，然后去最后几个周期的数据画图 你设置一下示波器显示的点数，可以只取5-10s，点数为1/仿真离散时间。
1、首先打开simulink的界液手面,选择设置。 2、其次在设置中下滑找到xygraph横纵坐标设置。 3、最后点击选项框中闹好嫌的xygraph横纵坐袜... 如何将simulink中示波器显示的图像纵坐标范围改变 直接在示波器界面点菜单栏的Y坐标 然后在图形上点鼠标就可以了 如何将simulink中示波器显示的图象纵坐标范围改变 仿真前将...
Hello, I need to plot exact the same graph as the output coming from a Schmitt Trigger by using only Simulink. No scopes shall be used since it has negative values on X axis, it should be demonstrated by a Simulink XY Graph block by creating appropriate inputs both for X and Y axes ...
Library: Simulink / Sinks HDL Coder / Sinks Description The XY Graph block displays an X-Y plot of its inputs in a MATLAB® figure window. The block has two scalar inputs. The block plots data from the first input (the x direction) against data from the second input (the y directio...
网络显示二维图形;显示输入信号的二维图形;显示平面图形 网络释义
在使用Simulink中的XY Graph时出的波形图没法像Scope的那样保存和导出图形,而使用截图工具又不够清晰或者规范,这时只需在命令行窗口中输入: >> set(0,'ShowHiddenHandles','on'); set(gcf,'menubar','figure') 就可以了,这样就和scope的图一样能导出、保存了。
I have scaled the max x min x, etc from the values that I see on the scope of my system, so I know the computer results are within the ranges needed on the Block Parameters screen. Despite this, no graph show up on the xy Graph. Any Ideas? 2 Comments Alex Alex on 8 Feb 2021...
(ECUTest/ControlDesk/TAE/TestStand/TPT)使用经验,具备至少一个完整的新 能源车 VCU 或三电系统的 HIL 测试项目经历; 5. 有主流 HIL 测试系统需求定义、方案设计、台架搭建、测试用例开发、自动化测试执 行等相关经验者优先; 6. 熟悉 MATLAB/Simulink,并具备运用其设计仿真模型的能力; 7. 易咖人才观:本分、...
利用Matlab软件的Simulink工具箱建立模糊控制系统的仿真实例。由于直接用模块搭建模糊自适应PID控制算法比较复杂,所以本文采用一种新的方法,即采用S-函数的形式来构造模块[4]。首先编写S-函数来表示模糊PID控制器的核心部分。 接下来构造模糊自适应PID的封装模块,其内外部结构图如图2、图3所示。
A dynamic model of the UPQC is developed in the MATLAB/SIMULINK environment and the simulation results demonstrating the power quality improvement in the system are presented for differen...