3) Using a DVM, check for voltage between the TIP and the driver transistor (point D). If it is equal to the solenoid power (~ 50 – 70 VDC) you have a shorted TIP. Replace the TIP with a TIP102 and driver transistor (see wiring diagram). If you have a shorted TIP, you likely...
79-15053-00 REV. C Page 1 of 16 Installation Instructions: Read these instructions in their entirety before performing any installation work. Rated for use on 110/120VAC 60Hz and 220/240VAC 60Hz applications WPC-1 ETL LISTED Conforms to UL STD 508;Certified to CSA STD C22.2 No. 14
The bridge rectifier diagram is also incorrectly rotated by 90 degrees.5.9.22 The Shadow Five Switch and Diode P.C.B. (A-13940)This board was used only on "The Shadow" to provide lamp matrix diode isolation for the 4 "Ring Grain of Wheat" lamps, in-situ.The bare board....
- Drawings: Provide the foundation drawing, electric scheme and wiring diagram, hydraulic drawing, pneumatic & electric pipeline drawing and other drawings requested by customer.- Installation and commissioning: TGMCO will send our technicians to customer's wo...
The bridge rectifier diagram is also incorrectly rotated by 90 degrees. 5.9.22 The Shadow Five Switch and Diode P.C.B. (A-13940) This board was used only on "The Shadow" to provide lamp matrix diode isolation for the 4 "Ring Grain of Wheat" lamps, in-situ. The bare board. This ...