there’s really not a whole lot you can or need to do. Trying to configure any form of authentication or encryption will drive away customers. You certainly don’t want the hassle of maintaining a user database and requiring people to log in. Recommended solution: get an AP that supports...
Security Policy WLANs are vulnerable to threats from unauthorized APs, STAs, and ad-hoc networks. Huawei WLAN devices use the following technologies to detect and contain rogue and interfering devices: The Wireless Intrusion Detection System (WIDS) can detect rogue and interfering APs, bridges, and...
When the Hello packets do not need to be authenticated on the local device and pass the authentication on the remote device, the two devices can establish the neighbor relationship. If the send-only parameter is not specified, ensure that passwords of all interfaces with the same level on the...
The ICV calculation for the data portion of the payload is run, and its result is compared with the value included in the incoming frame. If the values match, the data is considered to be valid (sent from the wireless client and unmodified in transit). If they do not match, the frame ...
30012, General: AP-manager interfaces count is less than number of active ports, and no LAG is configured. This is not a supported configuration When not using Link Aggregation (LAG), the number of connected ports, does not match the AP-manager interface count. This is not a supported conf...
Due to the EWC being deployed in fabric mode and the data plane using VXLAN, when the VLAN is viewed in the WLAN policy, the VLAN group does not match what was previously configured. To verify that the VLAN matches what was previously configured, go toConfigurationÒWireless...
If a firewall installation in the client packet path drops packets because the source IP address does not match the subnet on which the packets are received, this is useful. If the access-point group VLAN on the anchor controller is different than the WLAN interface VLAN on the...
If the connection test is not successful, continue to the next step. (Make sure that you re-enable your wireless security before you proceed.) To identify whether the issue is with the wireless signal from your router, try a wired connection to the router to see if that resolves your...
as shown below. As we are writing this, this feature is not yet working for all wireless network cards. For example, if you are using Prism II chip-based cards (made by Linksys, SMC, D-Link, and other OEM vendors), you will need to do extra work to make the device work under Win...
However, the user is not a member of the security group that is specified in the remote access policy. The authentication method specified in the Wireless Network (IEEE 802.11) Policies does not match the authentication method specified in the IAS remote access policy. For example, if network ...