If a Layer switch still exists between the 802.1X-enabled device and a user, Layer 2 transparent transmission must be configured on the switch. Otherwise, the EAP packet sent by the user cannot reach the authentication device and the user cannot pass authentication. To configure Layer 2 ...
Many laptops and tablets have a wireless switch on the front or side of the PC. If your PC has a switch, make sure that it's turned on. Some PCs also use a function key combination to turn the switch on or off. Check the info that came with your PC for details on locating...
However, 97% of ports in the current market are GE ports, and the actual tested network speed of Wi-Fi 7 mobile phones exceeds 4 Gbps. The uplink rate of APs will be 2.5 Gbps or more. Such a high uplink rate cannot be supported by today's GE switch ports at most enterprises. Tha...
CSS vs. CSS2 CSS technology development has gone through the following two stages: Traditional CSS: consists of two CSS connection modes, namely, clustering using CSS cards on MPUs and clustering using service ports. Cluster Switch System Generation 2 (CSS2): sets up a CSS by connecting CSS...
up in the cisco switch. I guess it seems to me that I figured that i could do this within VC but either I cant do this without trunking the uplinks or havent found the solution on the web interface. Problem is that I feel I dont have as much control over the network within VC or...
In this case, a pair of Nexus 5Ks is used which has the ability to house both LAN and SAN ports. This Nexus switch could also uplink into a “core” LAN/SAN. Many architectures are possible upstream. Note that while the LAN connections are cross connected between switches, the SAN ...
- Is it needed that the 2 6506-E switches are connected via supervisors uplink interfaces (slot 5 on this set-up, fa5/1-3 or tengig5/4-5) for SSO to work, or any interfaces on the modules can be used. Because, based on the curent set-up, they link the 2 6506-E switch using...
and the actual tested network speed of Wi-Fi 7 mobile phones exceeds 4 Gbps. The uplink rate of APs will be 2.5 Gbps or more. Such a high uplink rate cannot be supported by today's GE switch ports at most enterprises. That's why the global shipment of multi-GE ports increases by ...
If a Layer switch still exists between the 802.1X-enabled device and a user, Layer 2 transparent transmission must be configured on the switch. Otherwise, the EAP packet sent by the user cannot reach the authentication device and the user cannot pass authentication. To configure Layer 2 ...
up in the cisco switch. I guess it seems to me that I figured that i could do this within VC but either I cant do this without trunking the uplinks or havent found the solution on the web interface. Problem is that I feel I dont have as much control over the network within VC or...