What is the interface connecting the routing engine to the packet forwarding engine called?() A. Loopback 0 B. management C. internal(fxp1) D. control interface 相关知识点: 试题来源: 解析 C.internal(fxp1) ...
百度试题 结果1 题目What is the interface connecting the routing engine to the packet forwarding engine called?() A. Loopback 0 B. management C. internal(fxp1) D. control interface 相关知识点: 试题来源: 解析 C.internal(fxp1) 反馈 收藏 ...
In an NSSA LSA, when the output interface of the imported route is enabled in the same NSSA and the output interface is of the broadcast network type, the FA is the next-hop address of the redistributed route. Otherwise: If a loopback interface exists in an NSSA, the FA is the loop...
Public address: 202.96.128.5. This is the address of the WAN interface on the router. Internal address of the router: 192.168.2.1 Address of the server: 192.168.2.10 external port:80 Address of a local computer: 192.168.2.3 If a packet is sent to the public address by a computer at 192....
In IPv4, 127.0.0.1 is the most commonly used loopback address, however, this can range be extended to 127.255.255.255. Techopedia Explains Loopback Address The Loopback Interface The loopback address is a vital component of what IT experts call a loopback interface. The loopback interface refe...
a physical form. Instead, the network interface can be implemented in software. For example, the loopback interface (127.0.0.1for IPv4 and::1for IPv6) is not a physical device but a piece of software simulating a network interface. The loopback interface is commonly used in test ...
If no loopback interface is configured, the router selects the largest IP address among other interface addresses as its router ID. After the router has been running OSPF and selected its router ID, it still uses this router ID if the interface whose IP address is used as the router ID ...
If no loopback interface is configured, the router selects the largest IP address among other interface addresses as its router ID. After the router has been running OSPF and selected its router ID, it still uses this router ID if the interface whose IP address is used as the router ID ...
If no loopback interface is configured, the router selects the largest IP address among other interface addresses as its router ID. After the router has been running OSPF and selected its router ID, it still uses this router ID if the interface whose IP address is used as the router ID ...
If no loopback interface is configured, the router selects the largest IP address among other interface addresses as its router ID. After the router has been running OSPF and selected its router ID, it still uses this router ID if the interface whose IP address is used as the router ID ...