/* USER CODE BEGIN 2 */// ADC enable - to measure Vref.// Vref is internally connected to Vin[13]. Vref is used to calculate the Vpower level// and use that information to disable Option Bytes update.// ADC runs on INRCC->CCIPR|=0x80000000;// Select ADC clock = HSI1...
RCC->CFGR2 = 0x00000000; #else /* Disable all interrupts and clear pending bits */ RCC->CIR = 0x009F0000; #endif /* STM32F10X_CL */ #if defined (STM32F10X_HD) || (defined STM32F10X_XL) || (defined STM32F10X_HD_VL) #ifdef DATA_IN_ExtSRAM SystemInit_ExtMemCtl(); #endi...
The voltage is applied to the circuit through a bnc connector connected to a signal generator, in my case I use the Dc output option with high impedance on a normal signal generator. As for the code, I used stm32cubemx to generate some of the code but I didn't use any calibration fu...
DMA_InitTypeDef DMA_InitStructure;//时钟RCC_AHB1PeriphClockCmd(RCC_AHB1Periph_DMA2, ENABLE);//DMA设置DMA_InitStructure.DMA_Channel = DMA_Channel_2;//选择通道号DMA_InitStructure.DMA_PeripheralBaseAddr = (uint32_t)&(ADC3->DR);//外围设备地址,ADC_DR_DATA规则数据寄存器DMA_InitStructure.DMA_Memory...
#include “stm32f10x_rcc.h” GPIO_InitTypeDef GPIO_InitStructure; int i; #define LED_PORT GPIOB Void binky(); Void main() { Void binky(); } void binky(void) { RCC_APB2PeriphClockCmd(RCC_APB2Periph_GPIOB, ENABLE); //enable the PORTB pins// ...
根据学校的管理规定，从事教学工作的教师必须在课前备课，编写教案，并在每学期期末向学校上交教案。从教时间里,Z老师先后上交小学教案48册，这些教案都是他在参考别人教案的基础上独立创作的，而且没有留底稿，Z老师多次要求所在小学返还其教案，但该小学却以找不到为由拒绝返还。 该学校做法（）。
DMA_InitTypeDef DMA_InitStructure;//时钟RCC_AHB1PeriphClockCmd(RCC_AHB1Periph_DMA2, ENABLE);//DMA设置DMA_InitStructure.DMA_Channel = DMA_Channel_2;//选择通道号DMA_InitStructure.DMA_PeripheralBaseAddr = (uint32_t)&(ADC3->DR);//外围设备地址,ADC_DR_DATA规则数据寄存器DMA_InitStructure.DMA_Memory...