Command Line Interface $curl ifconfig.me⇒ 157.51.3.163 $curl ifconfig.me/ip⇒ 157.51.3.163 $curl ifconfig.me/ua⇒ Mozilla/5.0 (X11; Ubuntu; Linux x86_64; rv:94.0) Gecko/20100101 Firefox/94.0 $curl ifconfig.me/lang⇒ en-US,en;q=0.5 $curl ifconfig.me/encoding⇒ $curl ifconf...
An "ifconfig up eth0" activates eth0 but does not setup IP addresses, however an "ifup eth0" setup IP addresses or other options based by an ifcfg-eth0, because the "ifup" uses an "ifup-eth*" script. The ifup command will also configure any static routes that are configured in the...
On SUSE Linux, run the ifconfig command to check the network interface and find packet loss on the network adapter. Answer On SUSE Linux with kernel version 2.6.37 or a later version, the network adapter packet loss algor...
Standardize device configuration:Create standard configurations for each device classification on your network (routers, switches, network topology, etc.) so that you can avoid human error or other config errors when provisioning new devices.Configuration management softwareis the simple way to accomplish ...
On SUSE Linux, run the ifconfig command to check the network interface and find packet loss on the network adapter. Answer On SUSE Linux with kernel version 2.6.37 or a later version, the network adapter packet loss algorithm is changed. Packet loss data detected by the ifconfig command may...
ip – A Replacement for ifconfig ifconfighas been there for a long time and is still used to configure, display and control network interfaces by many, but a new alternative now exists on Linux distributions which is much more powerful than it. This alternative isipcommand fromiproute2utilpa...
Command Prompt (Windows): Open the command prompt and inputipconfig. Then, find “IPv4 Address” under the active network connection. This is usually displayed as127.0.0.1for localhost. Terminal (macOS/Linux): Open Terminal and then inputifconfigorhostname -I. Find the127.0.0.1address. ...
In a command-line environment, the commands ipconfig (for Windows network configuration) and ifconfig (for Linux network configuration, as well as Mac OSX and other Linux-like environments) allow you to view information about your network configuration and to configure your networsk interface. With...
So let’s check the details of this interface using theifconfigcommand: $ ifconfig eth0: flags=4163<UP,BROADCAST,RUNNING,MULTICAST> mtu 1450 inet 192.33.136.6 netmask 255.255.255.0 broadcast 192.33.136.255 ether 02:42:c0:21:88:06 txqueuelen 0 (Ethernet) RX packets 362 bytes 54226 (54.2 KB...
This feature enables you to configure MTU size by using an ONTAP Select multi-node cluster. An MTU is the maximum transmission unit size that specifies the jumbo frame size on 10 Gigabit interfaces as well as 1 Gigabit Ethernet. Using the ifconfig command, you can select the particular MTU...