Ethernet is commonly associated with connected devices in a wired LAN or WAN. Using a wired Ethernet cable, devices are connected to anEthernet switch. Ethernet has the ability to use both wired and fiber cables, delivering not only data but also power, now up to 90W with UPOE+. More form...
type: Defines the type of function. It can be one of the following, ‘function’, ‘constructor’, ‘receive' (forreceive ether function), or ‘fallback’ (fordefault function). name: Defines the name of the function. inputs: It is an array of objects which defines parameters; each obj...
what is difference between Switch stacking, etherchannel? Can anyone e jobsp90 Level 1 09-22-2024 12:52 AM If there are 2 switches stacked uplinks given to each 2 switches with 2 ports each, say eg port 47 & 48.Port 47 & 48 are created LACP for each switch Then ...
Fast EtherChannel (FEC): implements long-distance transmission through the mature KP4 FEC. PAM4: doubles the data rate without changing the baud rate, reducing the cost of optical interfaces. SPN integrates FlexE bonding and DWDM to flexibly expand and divide transport network bandwidth. FlexE bon...
C. There is an encapsulation mismatch between SW1’s Fa0/1 and SW2’s Fa0/1 interface. D. SW1’s Fa0/1 interface is administratively shut down. 相关知识点: 试题来源: 解析 A 正确答案:A 解析:EtherChannel中两个端口需要speed一致反馈 收藏 ...
Supports EtherChannel for increased bandwidth and redundancy between switches. Lower latency and higher performance than using a router. What is the Difference Between SVI and VLAN? A VLAN is a logical network segment that groups devices on the same Layer 2 domain. A VLAN creates a separate broa...
An Initial Coin Offering, also commonly referred to as an ICO, is a fundraising mechanism in which new projects sell their underlying crypto tokens.
What Is an Estoppel Certificate? What Is an ESG Rating? What Is Ethereum (ETH)? What Is the Efficient Market Hypothesis? What Is Equity Value? What Is the Equity Multiplier? What Is an Emerging Market Fund? What Is an Embargo?
What is the result of entering the command port-channel load-balance src-dst-ip on an EtherChannel link? () A. Packets are distributed across the ports in the channel based on both the source and destination MAC ...
There is no need for creating port-channel because whenever you configure an interface with channel-groupcommand, the port-channel is automatically created. Some useful commands: === ++ show etherchannel summary ++ show etherchannelsummary The below link might interest...