The direct extruder used by Snapmaker allows the extruder and nozzle to be in close proximity to each other, allowing the proper pressure to be applied to even the softest TPU filaments. As a result, temperature and speed settings can be set to fit TPU, and retraction can b...
Replace the 'X' at the end of the command with the number of your USB flash drive. After following the troubleshooting steps, if you find it difficult to resolve your issue, kindly submit a support ticket throughhttps://snapmaker.formcrafts.com/support-ticketand ...
the FDM printer squeezes plastic filaments through nozzles like toothpaste through a tube, only much tinier and one thin layer at a time. FDM is also referred to as FFF, for fused filament fabrication.
5.2 See if the LED is on when the toolhead approaches the palette knife or the Print Sheet. - If not, then the probe sensor itself is malfunctioning. Please contact us atsupport@snapmaker.comfor replacement. - If yes, go to step 6. 6. Do the following to ch...