A fillet weld is type of weld that has a roughly triangular cross section. A fillet weld typically requiresless joint preparation than a groove weld, making it a very cost-effective joining method and therefore considerably more abundant in the welding industry. Why is it called a fillet weld?
A connection in which two flat plates or two bars are welded to another flat plate at right angles and on the same axis. Lap Joint A connection between two overlapping parts making an angle to one another of 0-5° inclusive in the region of the weld or welds. Types of Welding Joints ...
Three regain types are created in the material because the contact temperature rises. The three types of regains are thermo-chemically-affected area, weld nugget, and heat-affected area. A weld nugget is a pool of melted metal that has cooled and solidified into a round joint. The thermo-me...
Product Description A flange is a part that is connected to each other between shafts and is used for the connection between pipe ends. There are also flanges used on the inlet and outlet of the equipment for the connection between two devices, such as reducer flan...
- Slip-on Flange: Slides over the end of a pipe and is typically welded in place. - Blind Flange: Has no bore and is used to block off the ends of pipes, valves, and pressure vessels. - Socket Weld Flange: Used with smaller diameter pipes and is welded to the pipe, with the pipe...
Premium B16.9 A403 WP304 Butt Weld Lap Joint Stub End Steel Pipe Cap is also called Steel Plug, it's usually welded to the pipe end or mounted on the external thread of the pipe end to cover the pipe fittings. To close the pipeline so the function is the s...
A pipe union is used to connect two pipes and the connection is a secure and semi-permanent.It is consisted of two pipes connected together via a third piece,and all the three parts are threaded.The pipe unions are similar to threaded couplings,they are usually easier to remove and allow ...
The American National Standards Institute (ANSI) Class 150 is a system of dimensional standards for weld neck, threaded, slip-on, lap joint, socket weld and blind flanges. Dimensions for facing, bolts and studs are also included in ANSI Class 150. ...
Jinan Hyupshin Flanges Co., Ltd, The types and specifications for steel flanges, Welding Neck Flange, Plate Flange, Slip On Flange, Blind Flange, Threaded Flange, Loose Flange, Lapped flange, Lap Joint Flange, Socket Weld Flange.
In pulsed mode, the current in each wire is pulsed alternately to avoid magnetic interactions between the two arcs. Welding commonly takes place with the two wires in line along the joint line, although the torch can be rotated across the joint to give a wider weld bead. Twin-wire GMAW ...