This oscilloscope is a really good choice for beginners with good user interface and menus that are intuitive to use. Also, TheHantek DSO5102Pis probably the best cheap oscilloscope you can get on the market be
a cap is a good cap if it isn't open circuited and the dome is flat, and you can further test it for a large AC voltage across it. If there is, the capacitor may be open or have a large ESR
If I want to see if there is direct contact in a connection, what's the difference between the resistance setting and the continuity setting on the multimeter? Won't both show whether there is a connection? The resistor setting would just show near 0 resistance. ...
Bodies with opposite charges attract, they exert a force on each other pulling them together. The magnitude of the force is proportional to the product of the charge on each mass. This is just like gravity, where we use the term “mass” to represent the quality of bodies that results in...
Insufficient battery power can cause sensors to stop reading, triggering a P0600 code. –Visually inspect all sensors and wires. Look for gaps in the insulation, corroded contacts, or severed wires. –Use a multimeter to check all parts of the wiring harness for continuity including all ground...
If you are confused with something, you may be a little bit up there in the knowledge. try to move down a little bit, and that confusion may dissapear by itself. I mean learn the EE first, then it will automatically tells you whats the OSC is for.same with multimeter (which my non...
Title:Re: Dou you know what this is? Post by:tomy983onMay 03, 2015, 10:19:28 pm My very low res multimeter says that the resistance of that pot goes from .1 to 2.5 ohms ~ Two are the disconnected wires: the gray one, attached from one side to the center of the pot ...