When we need to change the speed of an industrial motor, whether to control a process or save energy costs, we turn to the variable frequency drive, better known simply as a VFD.
Hello everyone, I am Rose. Today I will introduce VFD to you. A variable frequency drive (VFD) is a power control device that uses power electrical te...
Maximum speed, usually set to50 Hz, but often set to a higher speed to suit the application. Ensure that the maximum speed does not take the drivebeyond the loadability limit. 2. Minimum speed Minimum speed,usually 0 Hz for a pump orfan drive, but often set at a higher speed to suit...
I have a noticeable hand tremor that's always lead me to believe smt would be off limits but it looks like this guy has one too and does a pretty good job here. What kind of protoboard do you use for smt? There seems to be a few different layouts available. ...
We have all seen the motor nameplate attached on the motor side. All motors have a permanent nameplate which lists all important data, further data is
- If the machine does not have the table included, then a table will need to be built. The rails, chain and chain mounts are included that are used on this table. Additional Information: Respond: Other Possible Solutions to this Question...
Some shops have core loss testers and can screen motors determine if they are repairable prior to stripping. The repair shop should also determine and eliminate the cause for a motor’s failure. Aside from proper strip-ping procedures, the motor owner should ensure that the rewind shop does th...