In this section, the proposed approach will be explained in detail. First, the basic concepts and methods will be discussed; then, each of the operators and mechanisms included in the hybrid approach will be presented in their respective sub-sections. Finally, we connect all the described method...
With the increase in demand for plastic use, waste plastic (WP) management remains a challenge in the contemporary world due to the lack of sustainable efforts to tackle it. The increment in WPs is proportional to man’s demand and use of plastics, and t
This can be explained partly because of the low gradient between the waste heat temperature and the average ambient temperature. This reduces the amount of heat available. Secondly, the study focused on identifying the amount of heat that can be easily recovered and when the temperatures at which...
effluent. The cleaner production hierarchy to eliminate all pollutants and approach zero waste/pollution should start from raw material selection to recycling, all the way to product modifications in order to avoid end of pipe treatment (El Haggar 2001c)as will be explained throughout this chapter...
pipe. Due to the typical fall or slope of a waste water conduit, the further the vessel is located from the building, likely the deeper it will have to be buried. In most cases it will be preferable to position the top of the vessel to be accessible from above the ground to permit ...
{o}}are functions of both geometric and flow parameters, with results for steady Poiseuille flow in a circular pipe provided by Taylor27and Aris32, and results for a concentric circular annular pipe in steady and oscillatory Poiseuille flows given by Aris33and Tsangaris and Athanassiadis34, ...
different directions, it is customary to lay the pipeline in sections which start at a low point and slope upward to a high point. At the low point, the liquid in the pipe is sometimes raised by pumping equipment to the next high point of the pipe section where it begins its movement ...
return Pipeable::pipe(std::forward<generator<T>>(src), std::forward<Pipeable>(pipe)); } The next step could be to implement Where as a pipeable type. Rather than just a function, Where now becomes an invokable type, a class with a call operator that implements the logic to filter ...
As explained earlier the fluid properties of the biodegradable drilling mud as well as water-based drilling mud were measured during the experiment and were tabulated in Table 4. The properties include mud weight, pH, gel strength, thickness of filter cakes, filtration properties, apparent and plas...
In addition, the set up was modified by introducing a rotameter (TECH FLUID) in an influent pipe to adjust the volumetric flow rate. The mass of adsorbent loaded into the column was 10.19 kg with a media size of 4.75, which occupied a bed height of 29 cm, which was a bed volume (...