· Before you delete a dynamic VLAN or a VLAN locked by an application, you must first remove the configuration from the VLAN. Creating VLANs 1. Enter system view. system-view 2. Create one or multiple VLANs. ¡ Create a VLAN and enter its view. vlan vlan-id ¡ Create multiple...
Configuration restrictions and guidelines The VLAN ID value range supported by an IRF 3.1 system depends on PEXs. For more information, see PEX manuals. Configuring basic VLAN settings Step Command Remarks 1. Enter system view. system-view N/A 2. (Optional.) Create a VLAN and enter its ...
In this mode, VTP mode and domain name are saved in the device running configuration, and you can save this information in the device startup configuration file by using the copy running-config startup-config privileged EXEC command. In a device stac...
Step 1 configure terminal Example: Switch# configure terminal Enters the global configuration mode. Step 2 no vlan vlan-id Example: Switch(config)# no vlan 4 Removes the VLAN by entering the VLAN ID. Step 3 end Example: Switch(config...
To configure this function on multiple interfaces, repeat this step. interface interface-type interface-number port mux-vlan enable vlan { vlan-id1 [ to vlan-id2 ] } &<1-10> quit Verifying the Configuration Run the display mux-vlan command to check the MUX VLAN configuration....
Note -If you change any of the VLAN configuration parameters, you must reboot the system before the changes take effect. If you make changes and do not reboot, you might experience configuration problems. VLANOverview With multiple VLANs on a card, a server with a single card can have a ...
This document describes the configuration of Ethernet services, including configuring MAC address table, link aggregation, VLANs, VLAN aggregation, MUX VLAN, VLAN termination, Voice VLAN, VLAN mapping, QinQ, GVRP, VCMP, STP/RSTP/MSTP, VBST, SEP, RRPP, ERPS, LBDT, and Layer 2 protocol transpare...
The vlanInterface configuration policy can be applied at the network level. By setting roles on target devices and interfaces, inheritance is used to apply the configuration policy to the appropriate devices and interfaces. Separate instances of the vlanInterface configuration policy are used to configu...
In the first network tagged and isolated by the Docker host, eth0.20 is the parent interface tagged with VLAN id 20 specified with -o parent=eth0.20. Other naming formats can be used, but the links need to be added and deleted manually using ip link or Linux configuration files. As long...
Download the VLAN configuration fileH48712_interfaces.rtffromhttps://ibm.ent.box.com/file/800996320730. Note:If you do not have access to the above link, seeFull output of the interface file. Gain sudo rights by using the following command: ...