used for the programming.Make sure pinout is compatible.Close pin 11-12for self-programming Fig.6 B.Close JP1pin 11-12so that the MCU is accessable by programmer..C.Select power supply for the MCU.It can be powered from USB or programmer.Close JP1pin 13-14if powered from programmer.Se...
Program allow you to program flash memory on the protocols spi, I2C, MicroWire. Supports CH341a, CH347, UsbAsp, AVRISP(LUFA), Arduino, FT232H. - nofeletru/UsbAsp-flash
Connect your favorite programmer to the header of USB ISP referring to the pinout on the case of the device. If you don't have one around, then use an Arduino with ArduinoISP example running on it. It is supported by avrdude as avrisp. Be sure to set baud rate to 19200. Upload the...
Hi! I go this strange error and AFAIK I've never seen this before. I'm trying to upload code to an ATmega324PB (MightyCore) and have the following platformio.ini file ; ENVIRONMENT SETTINGS [env:MightyCore] platform = atmelavr framework ...
AsProgrammer dregmod allow you to program flash memory on the protocols spi, I2C, MicroWire. Supports Buzzpirat, Bus Pirate, CH341a, CH347, UsbAsp, AVRISP(LUFA), Arduino & FT232H - therealdreg/asprogrammer-dregmod
remove JP2 Self program bridge Pinout Testing (Linux) Connect the flashed USBasp device to your linux machine install i2c-tools package (e.g. sudo apt install i2c-tools) run i2cdetect -l, i2-tiny-usb interface should be listedAbout Cheap and simple I²C to USB interface based on USBasp...