instead of “Arduino Pro Mini 3.3V”, or customize boards.txt. To quickly tell which loader is installed on a Pro Mini, count the number of green LED flashes after a reset: the standard bootloader flashes
Updated source so that it compiles with current arduino-IDE (1.8.12) provided avr-gcc (7.3.0) Patched to fix issue msproul#7
12-windows\\arduino-1.8.12\\hardware\\arduino_nulllab\\avr_compatible\\bootloaders\\lgt8fx8p//" # 1 "D:\\arduino-1.8.15\\hardware\\lgt\\arduino_nulllab\\bootloaders\\lgt8fx8p//" # 1 "<built-in>" # 1 "" # 1 "baudcheck.c" 53 changes: 1 addition & 52 deletions 53 bootloa...
"gcc", "stdc++", "app_trace", "app_update", "bootloader_support", "bt", "btdm_app", "c", "c_nano", "coap", "coexist", "console", "core", "cxx", "driver", "esp32", "esp_adc_cal", "espnow", "ethernet", "expat", "fatfs", "freertos", "hal", "heap", "jsmn",...
261 + - If you use an Arduino, use BLHeliSuite to flash the 1-wire sketch. Below you see an Arduino Nano Clone with Atmega328p (old Bootloader).266 262 - Connect PWM-Signal and GND between Interface and ESC. On the Arduino, PWM is connected to D3....
Hello, I setup chinese Nano 3.0 board with esp-link controller and everything works like charm. Then i tried to replace Nano with chinese 'micro' boards on 32u4 chip and none of them is accept firmware upload. I tried change port speed e...