Currently, it will be using the Dockers internal IP rather than the host IP. To set this option, you must first switch to the settings page by clicking the cog in the sidebar. 16. Once you are on the settings screen, change to the “System” menu (1.). After changing to the ...
Flood Lights: switch to enable/disable status light All Devices(Disabled by default): Switch to enable/disable SSH access Light A light entity will be created for each UniFi Floodlight found. This works as a normal light entity, and has a brightness scale also. ...
NEW: Added unifiprotect.set_default_doorbell_text service to allow you to set your default Doorbell message text. NOTE: After running this service, you must restart Home Assistant for the default to be reflected in the options. NEW: Added "SSH Enabled" switch for all adoptable UniFi Protect ...
set interfaces wireguard wg0 address 10.0.1.1/24 set interfaces wireguard wg0 listen-port 51820 set interfaces wireguard wg0 route-allowed-ips true set interfaces wireguard wg0 private-key /config/auth/wg.key # Set up the allowed peers (ie. clients). set interfaces wireguard wg0 peer (see ...
-Raspberry pi 4b as a Unifi controller is connected to Unifiswitch port 8 as 192.168.69.2 -I'd like the pfsense to assign IP's and not the Unifi switch 8 In pfsense, I've setup a vlan as follows: -Interfaces > interface assignments > vlans > vlan config: parent interface igb0 (sam...
ip-address 192.168.1.18 mac-address 00:1b:a9:bd:25:2d } static-mapping 00-ee-22-aa-18-ba { host-record disable ip-address 192.168.1.51 mac-address 00:ee:22:aa:18:ba } static-mapping 7c-dd-90-a7-6f-56 { host-record disable ...
ssh ubnt@$AP-IP set-inform http://$address:8080/inform The default device password is ubnt. $address is the IP address of the host you are running this container on and $AP-IP is the Access Point IP address. When using a Security Gateway (router) it could be that network connected...
ssh ubnt@$AP-IP set-inform http://$address:8080/inform The default device password isubnt.$addressis the IP address of the host you are running this container on and$AP-IPis the Access Point IP address. When using a Security Gateway (router) it could be that network connected devices ...
ssh ubnt@$AP-IP set-inform http://$address:8080/inform The default device password is ubnt. $address is the IP address of the host you are running this container on and $AP-IP is the Access Point IP address. When using a Security Gateway (router) it could be that network connected...
ssh ubnt@$AP-IP set-inform http://$address:8080/inform The default device password is ubnt. $address is the IP address of the host you are running this container on and $AP-IP is the Access Point IP address. When using a Security Gateway (router) it could be that network connected...