root@UCG-Max:/data/dhcpv6-mod# ./install-dhcpv6-mod.sh [install-dhcpv6-mod] copied dhcpv6-orange.conf default config to /data/local/etc/dhcpv6.conf [install-dhcpv6-mod] /usr/sbin/odhcp6c detected as an original Unifi executable, we can rename it [install-dhcpv6-mod] /usr/sbin/odhcp6c...
[--debug-packets] IF_WAN IF_ROUTER positional arguments: IF_WAN interface of the AT&T ONT/WAN IF_ROUTER interface of the AT&T router optional arguments: -h, --help show this help message and exit checking whether WAN is up: --ping-gateway normally the WAN is considered up if the IF_...
At this stage, you should have a working WireGuard setup. You can verify that a network interface (wg0) has been created and configured with the following commands: $ sudo wg show interface: wg0 public key: (see pg.public on usg) private key: (see /config/auth/wg.key on usg) listen...
ssh { port 22 protocol-version v2 } } system { conntrack { expect-table-size 2048 hash-size 32768 modules { sip { disable } } table-size 262144 timeout { icmp 30 other 600 tcp { close 10 close-wait 60 ...
I could connect to them via SSH but not the web, and all the instructions I found to update the firmware used the web interface. Turns out, I needed to preface the IP address with https:// using the IP alone or http:// would not resolve the web portal. After I figured that ...
package.json Small improvements over connectSSH Apr 3, 2017 Repository files navigation README GPL-2.0 license UNIFICli Experimental CLI based on node-unifiapi allowing remote CLI access to Ubiquiti Unifi REST API commands over direct HTTPS session or via Unifi Cloud, to Ubiquiti Controller / Ubiqu...
Therefore I had to flash the AP again using the ruckus credentials for SSH access (super/sp-admin). Is it possible that the join process somehow uses the other firmware on the AP to boot? What would happen if I flash the new firmware on both firmware partitions (mtd5 and mtd7)?