There are 4 main methods toresetting a UniFi Access Point: UniFi Physical factory reset, UniFi Controller factory reset, UniFi Debug Terminal Window Reset, and UniFi SSH factory reset. UniFi Physical Factory Reset Perhaps the most common way ofresetting UniFi access pointsis by physically pressing ...
2. Once you have installed Docker, you will want to add your current user to the “docker” group using the chmod command. sudo usermod -aG docker $USERCopy 3. After changing a user’s groups, you must either log out or restart your system. If you use an SSH connection, you can lo...
Note : if you add -f to the install command, a filtered tail -f /var/log/daemon.log will automatically be executed at the end (you must Control-C to exit).The install-dhcpv6-mod.sh command must be issued :when installing dhcpv6-mod for the first time, of course when dhcpv6-mod ...
so that seeming proves the generic repo was working. But then the opnsense repos didn't work any more and neither "pkg update" in ssh nor "check for updates" in the gui worked any more (for normal opnsense stuff). The gui also showed all installed plugins as orphaned, regardless which...
How i did it was, using WINSCP > putty, i logged into the QNAP NAS ssh. Then i select the networks (this is from the qnap ssh default feature), and from here i can see which is the active network port being used (i saw 5 interfaces, only 1 was active) Next i exited to the ...
SSH into the AP (default password is ubnt) Execute the reset command: syswrapper.sh restore-default Execute the set-inform command with the IP address of your Unifi controller in Azure: set-inform http://<your VM DNS name>:8080/inform. Note, you can find the DNS name on the overview...
To use SSH If you can SSH into the AP, it's possible to do L3-adoption via a under-construction CLI command: # 1. make sure the AP is running the latest (or 2.1.0+)# if it's not, do# syswrapper.sh upgrade http://ip-of-controller:8080/dl/firmware/BZ2/version-of-ap-see-ref...
Could the model be set with the rpmkey command as well? When I tried to join the ap my to my test vSZ, I found that the AP rebooted and came back with the xclaim-FW but with the ruckus user/pw. Therefore I had to flash the AP again using the ruckus credentials for SSH acces...
Describe the bug I have a few Unifi AP-LR running OEM firmware which is a nightmare to reconfigure. I wanted to flash one with OpenWRT as i have so far only had very good experiences with OpenWRT-supported devices. This specific model do...
Flood Lights: switch to enable/disable status light All Devices(Disabled by default): Switch to enable/disable SSH access Light A light entity will be created for each UniFi Floodlight found. This works as a normal light entity, and has a brightness scale also. ...