I have ncountred many issue with the reset trough the ssh with the command syswrapper.sh restore-default finaly i have found another command and the reset is working fine : syswrapper.sh restore-default & set-default & Regards Reply Luke Cuddehay February 1, 2024 at 09:49 Thank you...
Describe the bug I have a few Unifi AP-LR running OEM firmware which is a nightmare to reconfigure. I wanted to flash one with OpenWRT as i have so far only had very good experiences with OpenWRT-supported devices. This specific model do...
Additional command line scripts exist on the Unifi access point that offer additional functionality not covered by the tooling used. The syswrapper.sh script appears to contain a large number of potentially useful subcommands. The set-locate and unset-locate subcommands were used by the app to ...
I foolishly factory reset it and now it is in a loop where it will boot for about 2 minutes and then reset itself. I have tapped into the serial header on the board and I do have a u-boot prompt. I have tried the bootnet command, which will transfer a firmware file successfully...
If you can SSH into the AP, it's possible to do L3-adoption via a under-construction CLI command: # 1. make sure the AP is running the latest (or 2.1.0+)# if it's not, do# syswrapper.sh upgrade http://ip-of-controller:8080/dl/firmware/BZ2/version-of-ap-see-ref-table-below...
Every 10s, the AP sends an HTTP POST containing it's current status to the "inform URL". The controller will either respond with a no-op message or with a command message. Upon receiving a command message, an AP will execute a command and then send another inform immediately. ...