I won't be able to do so until tomorrow but if you were able to restore functionality by removing it, we at least can say that it has something to do with it. I think the underlying issue here is, that the Intercom is not really a protect device as it just gets relayed via Access...
In order to manually adopt a device take these steps: ssh ubnt@$AP-IP set-inform http://$address:8080/inform The default device password isubnt.$addressis the IP address of the host you are running this container on and$AP-IPis the Access Point IP address. ...
SSH information Username = root Password = Your UI account password used when you setup the device. NOTE: Changing your UI SSO password will update for authentication to the controller, but will NOT change the device SSH credentials. This means that it will continue to be the password you use...
we wouldstrongly reocmmendusinga single,centrally managed, Controller instance.This way you can remotely adoptUnifi devices to your Controllervia SSH orby using theDiscovery Tool, you can find details on the process
6. Login to your NAS via SSH 7. Code:Select all sudo -u admin -s 8. Code:Select all docker compose up -d whereever you've saved the docker-compose.yml 9. Wait a little 10. Access << IP YOU WILL ACCESS CONTROLLER WITH >>:8080 ...
We cycled through 25GbE ports. We tried different NICs. We could adopt the switch. We could SSH into the switch. The switch could see the controller, and even trying manual inform commands via SSH did not work. Ubiquiti USW Leaf CLI Login Via SSH Ping Controller ...
SSH into the AP (default password is ubnt) Execute the reset command: syswrapper.sh restore-default Execute the set-inform command with the IP address of your Unifi controller in Azure: set-inform http://<your VM DNS name>:8080/inform. Note, you can find the DNS name on the overview...
In order to manually adopt a device take these steps: ssh ubnt@$AP-IP set-inform http://$address:8080/inform The default device password is ubnt. $address is the IP address of the host you are running this container on and $AP-IP is the Access Point IP address. When using a Secur...
The default example requires some l3 adoption method. You have a couple options to adopt.SSH AdoptionThe quickest one off method is to ssh into the access point and run the following commandsmca-cli set-inform http://<host_ip>:8080/inform ...
Alternatively to manually adopt a device take these steps: ssh ubnt@$AP-IP set-inform http://$address:8080/inform Use ubnt as the password to login and $address is the IP address of the host you are running this container on and $AP-IP is the Access Point IP address. Docker Mods ...