61、将时间写入CMOS hwclock-systohc查看CMOS时间hwclock-show读取CMOS时间hwclock-hctosys从效劳器上同步时间s ontpdate ntp.untu so ntpdate 设置电脑的时区为上海s ocp/usr/share/zoneinfo/Asia/Shanghai/etc/localtime XP和untu相差了8小时的时差#关闭UTC,将当前时间写入CMOS。s osed-ie's/UTC=yes/UTC=...
Sample output: Check status: sudo systemctl status v2ray If it’s not running, then restart it. sudo systemctl restart v2ray Enable auto-start at system boot time. sudo systemctl enable v2ray Step 2: Set Up NTP Time Sync It’s very important that your server has accurate time, or V2...
Ubuntu 16.04でntp.serviceはntpインストール時にenableになっているのに、OS起動時にntp.serviceが停止しているという現象が発生した。 $ ntpq -p ntpq: read: Connection refused $ systemctl status ntp.service ● ntp.service - LSB: Start NTP daemon Loaded: loaded (/etc/init.d/ntp; bad; ven...
$ sudo systemctl status ntp Verify NTP Status IfUFW firewall is enabled, we need to allowNTPservice across it so that client machines can access the NTP server. $ sudo ufw allow ntp OR $ sudo ufw allow 123/udp To implement the changes, reload the firewall as shown. ...
The third field shows the reference clock type and unit number (but if you are running in the peer address in dotted-quad notation instead) The fourth field is a status word, encoded in hex in the format described in Appendix A of the NTP specification RFC 1305. The final four fields ...
Start the NTP service and ensure it’s running. sudo service ntp start sudo service ntp status Ensure that NTP is synchronizing Ceph monitor node clocks properly. ntpq -p 1.6. Install SSH Server Copier lien For ALL Ceph Nodes perform the following steps: Install an S...
查看进程状况 sudo service ntp status 上面的命令能够查看 NTP 的状态。 启动进程 sudo service ntp st...
$ timedatectl timesync-status Server: 91.189.89.198 (ntp.ubuntu.com) Poll interval: 4min 16s (min: 32s; max 34min 8s) Leap: normal Version: 4 Stratum: 2 Reference: 11FD22FB Precision: 1us (-23) Root distance: 30.234ms (max: 5s) Offset: +33.938ms Delay: 14.975ms Jitter: 37.394ms...
ntpdate ntp.aliyun.com #修改/etc/fstab文件注释掉带/swap.img的这一行 vim /etc/fstab # 设置所需的 sysctl 参数,参数在重新启动后保持不变 cat <<EOF | sudo tee /etc/sysctl.d/k8s.conf net.ipv4.ip_forward = 1 EOF # 应用 sysctl 参数而不重新启动 ...
Try sudo /etc/init.d/ntp status to check if NTP is running, and sudo /etc/init.d/ntp restart to restart it if necessary. I have various systems on unreliable networks so I use a simple script to bounce NTP if needed: $ cat /etc/cron.hourly/BOUNCE-NTP #...