i flashed the jetson os again,and it showed"Flashing Jetson OS Success"on sdkmanager pane,then i can ping the ip 192.168.55.1 out now,but it stoped when doing “Install SDK components on your Jetson Tx2” with error"Cannot connect to the device via SSH",the same problem like i met...
Yes. The TX2 board has two usb ports. The smaller one is usb 2.0 and the other is usb 3.0. My hub was connected to usb 3.0 port. But lsusb shows it was connected to the usb 2.0 port. And if I connect my hub to usb 2.0 port, it works fine in usb 2.0 mode. I also tried to...
(much of the answer would be the same for TX1 or TX2, but some parts might differ…the question needs to be consolidated to either the TX1 or TX2 forum)WayneWWW 2017 年5 月 4 日 10:00 7 You meant HDMI cannot work if you connect it and boot up??Wayne...
The host PC is any external x86_64 (64-bit Intel CPU-based) ordinary desktop computer. This is required for a Jetson in recovery mode because the Jetson becomes a custom device over USB in that case…the “driver package” (which JetPack is a front end to even if you choose to use ...
ssh: connect to host 192.168.55.1 port 22: Connection timed out ip addr does not show 192.168.55.100 - which is probably why the ssh doesnt work.JohnU-PNSR 2019 年3 月 21 日 16:35 12 i have a further question, why does the installer choose to do all these things without asking firs...