TX driver issue detected, PF reset issued* How to setup and detail results + I got 2 machines each with 1 X710 4ports 10G cards. These 2 X710 cards has direct cable connect between them. + On machine 1, I run the following commands to create VF0...
Issue Intel X710 i40e-based NIC resets under load: Raw kernel: i40e 0000:01:00.1: TX driver issue detected, PF reset issued Environment Red Hat Enterprise Linux (RHEL) 7 Red Hat Enterprise Linux (RHEL) 6 Intel network interface withi40edriver module ...
The cards at first seem to work well and preform well however we now have an issue where the links on all of our hots flap and performance is very poor.The logs show TX driver issue detected, PF reset issued. and drop packages. I search information and show issues ...
DriverHost (SM-HV01) Code: root@SM-HV01:~# ethtool -i enp3s0f0 driver: ixgbe version: 5.18.6 firmware-version: 0x80000835, 1.1200.0 expansion-rom-version: bus-info: 0000:03:00.0 supports-statistics: yes supports-test: yes supports-eeprom-access: yes supports-register-dump: yes ...
EAL: Probe PCI driver: net_ixgbe_vf (8086:1565) device: 0000:02:10.0 (socket -1)eth_ixgbevf_dev_init(): VF Initialization Failure: -15,: ../drivers/net/ixgbe/ixgbe_ethdev.c: 1683 (The error code is not always -15, I have seen other values during the same pr...
Issue Link is not detected for an interface, while speed and duplex options are present. Messages like the followings are present in the logs: Raw May 29 15:10:07 kernel: [ 4.424591] i40e 0000:5d:00.0: eeprom check failed (-2), Tx/Rx traffic disabled ...
> Kernel driver in use: ixgbe This time I'll reboot the machine, and also try "iommu=pt" as suggested in different places for use with 10G NICs. Regards, Lutz Vieweg On 06/07/2016 05:47 PM, Alexander Duyck wrote: > On Tue, Jun 7, 2016 at 2:35 AM, Lutz Vieweg <l...@5t9....
YES - last one was OEM clear driver install - NO HW CHANGES The wireless card, did you purchased it separately or did it came installed in the computer? Installed When did the issue start? Just few minutes after unboxing the machine 1) machine turned first on : 6/6/...
The ixgbe driver shipped by Ubuntu with this kernel (3.2.9-k2) is somewhat dated, although. Currently, we don't see this issue anymore, perhaps due to disabling the bridge-nf settings. Thanks! Alex. 翻譯 0 積分 複製連結 回覆 所有論壇主...
The ixgbe driver shipped by Ubuntu with this kernel (3.2.9-k2) is somewhat dated, although. Currently, we don't see this issue anymore, perhaps due to disabling the bridge-nf settings. Thanks! Alex. Translate 0 Kudos Copy link Reply All for...