tunnel local命令用来配置隧道的本端地址。 undo tunnel local命令用来取消上述配置。 缺省情况下,系统没有配置IPSec隧道的本端地址。 命令格式 tunnel local { ipv4-address | applied-interface } undo tunnel local 参数说明 参数参数说明取值 ipv4-address 指定IPSec隧道的本端IPv4地址。 点分十进制格式。 applied...
该命令功能等同于命令tunnel localapplied-interface。
A Tunnel Interface represents the tunnel through which network traffic from the configured SSIDs can be routed to a remote endpoint. Using this feature you can configure Ethernet over Generic Routing Encapsulation (EoGRE), EoGRE over Internet Protocol security (IPsec ), or Virtual Extensible Local ...
ClickAdd Tunnel Interface. Configure primary endpoint as shown below: You can optionally configure a secondary endpoint as shown below: Create an SSID Profile with a valid VLAN ID (e.g. 10 as discussed above) and add the recently created Remote-vxlan-bridging network profile to it. ...
Unhealthy- Server configuration couldn't be applied. Server logs– Determines if logs have been uploaded to the server within the last 60 minutes. Healthy- Server logs were uploaded within the last 60 minutes. Unhealthy- Server logs haven't been uploaded in the last 60 minutes. ...
Device(config)#sdwanDevice(config-sdwan)#interface GigabitEthernetDevice(config-interface-GigabitEthernet)auto-bandwidth-detect Table 1.Related Commands Command Description iperf-server Specifies a local iPerf3 server that a device contacts to perform a speed test for automatic ...
VRFs. Route leaking between Global Routing Table (GRT) and Virtual Routing and Forwarding (VRF) table is done with the use of static routes. Either method provides the next-hop IP address (for the multi-access segment) or points the route out of an interface (point-to-p...
netsh interface portproxy add v4tov4 listenport=3390 listenaddress=192.168.1.111 connectport=3389 connectaddress=192.168.0.33 where 192.168.1.111 is IP of your Windows machine and 192.168.0.33 is destination server. From your Mac you will connect to Windows machine specifying port in RDP connection...
tunnel local { ipv4-address | applied-interface } undo tunnel local 参数说明 参数参数说明取值 ipv4-address 指定IPSec隧道的本端IPv4地址。 点分十进制格式。 applied-interface 指定安全策略接口的主地址为IPSec隧道的本端地址。 说明: 该参数只在ISAKMP方式安全策略视图下有效。 - 视图 手工方式IPSec安全策略视...
当安全策略实际绑定的接口配置了多个IP地址(一个主IP地址和多个从IP地址)时,可以执行命令tunnel local ipv4-address指定其中一个IP地址作为IPSec隧道的本端IP地址,也可以执行命令tunnel local applied-interface指定该接口的主地址作为IPSec隧道的本端地址。 当本端与对端存在等价路由时,可以执行命令tunnel local来指定IP...