1) tribo-oxidation 摩擦氧化 1. The interface slip is enhanced,the oxidative debris becomes difficult to remove,hence the wear is reduced due to thetribo-oxidation. 摩擦氧化在扭动微动接触界面不仅增加了界面滑移,而且产生的氧化磨屑不易排出接触区,因此有利于减少磨损。
Tribo-Oxidation TestRotary pressure vessel oxidation test To investigate influence of friction on ageing behavior of biological esters, a so-called tribo-oxidation test has been designed. Therefore, a tribometer has been...doi:10.1007/978-3-642-22647-2_142Jan Schumacher...
A simple tribo-oxidation wear model was developed and a very good correlation was observed with experiments as long as the compaction of debris layer leading to a glaze layer structure was not activated.doi:10.1016/j.triboint.2018.04.032Dréano, Alixe...
Raman microspectroscopy was found to be essential to identify different oxide and borate phases on the wear tracks, which originate from tribochemical reactions and tribooxidation. Furthermore, it was shown that the temperature dependence of tribological reactions at the interface can successfully be ...
Despite their strong oxidation resistance of the high-entropy phases, tribooxide films form in conditions of high temperature and localize severe plastic deformation on (AlCrZrTiTa)N coating during dry high-speed cutting. At the early stage, in equilibrium, chromium tribooxide is forming, while ...
new levels of performance. Recently Whyco addressed several tribological challenges adding its Triboslide and Cerafuse coatings to the company’s offerings. Whyco is renowned for innovative solutions designed to address very specific industry, regulatory, and end product performance issues. The ...
This paves the way for extending the lifetime of contacts evincing tribo‐oxidation.doi:10.1002/admi.202001673Lehmann, Julia S.Schwaiger, RuthRinke, MonikaGreiner, ChristianAdvanced Materials Interfaces
Tribo-oxidation products on the worn surface were analyzed by X-ray photoelectron spectroscopy (XPS). The results showed that as temperature increased from 25 °C to 800 °C, the specific wear-rates (WRs) of the composites decreased from 103 mm3N1m1 to 104 mm3N1m1 when coupled with Al2O...
The oxides represent the late stages of a copper–sapphire triboヽontact, once the whole copper surface is covered with an oxide. For this purpose, high﹑urity copper, thermally﹐xidized and sintered Cu2O and CuO samples are tribologically loaded and eventually formed wear particles analyzed. ...
Rasool, G.Stack, M. M.Tribology InternationalRASOOLG,STACK M M.Tribo-oxidation maps for Ti against steel [ J ].Tribology International, 2015,91 : 258 - 266.Rasool G, Stack MM (2015) Tribo-oxidation maps for Ti against steel. J Tribol Int 9:258-266...