The tracert command checks the path of packets from the source to the destination, checks network connectivity, and locates a network fault. Format tracert [ -a source-ip-address | -f first-ttl | -m max-ttl | -name | -p port | -q nqueries | -s packetsize | -w timeout ] * ...
Tracert Command Format tracert [ -a source-ip-address | -f first-ttl | -m max-ttl | -p port | -q nqueries | -w timeout ] *host -a: specifies the source address. If this parameter is not specified, the IP address of the outbound interface is used as the source IP address of ...
TRACERT prints out an ordered list of the intermediate routers that return ICMP "Time Exceeded" messages. Using the -d option with the tracert command instructs TRACERT not to perform a DNS lookup on each IP address, so that TRACERT reports the IP address of...
TargetName Specifies the destination, identified either by IP address or host name.-? Displays help at the command prompt.RemarksThis diagnostic tool determines the path taken to a destination by sending ICMP Echo Request messages with varying Time to Live (TTL) values to the destination. Each ...
使用NT系统中的Tracert命令:(用户可用:开始->运行,输入"command" 调出command窗口使用此命令) C:\\>tracertwww.yahoo.com Tracing route towww.yahoo.com[204.71.200.75] over a maximum of 30 hops: 1 161 ms 150 ms 160 ms 202.99.38.67 2 151 ms 160 ms 160 ms 202.99.38.65 ...
nslookup [IP Address]:This will perform a reverse-DNS lookup and will try to match the given IP address in the command with its corresponding domain name. Example: nslookup 8.8.8.8 As shown on the screenshot above, the IP address 8.8.8.8 is mapped with the name “google-public-dns-a....
If thehost_namevalue is specified as a host name (not an IP address), the command invokes the resolver to obtain an IP address for thehost_namevalue. The command uses the first IP address that is returned by the resolver. You can use the ADDRTYPE option to determine whether the command...
Following is an example of atracertcommand output. Beginning with the first entry, it shows each router discovered on the way to the final destination in sequence; after the first two routers the trace reaches its destination. The lines of the tracert display have been indented for readability....
By default, tracert queries both IPv4 and IPv6 addresses when you specify a host name for destination. You can override this behavior by using the -4 or -6 option.The tracert command-line tool determines the path to the destination by examining the ICMP Time Exceeded messages returned by ...
The tracert command checks the path of packets from the source to the destination, checks network connectivity, and locates a network fault. Format tracert [ -a source-ip-address | -f first-ttl | -m max-ttl | -name | -p port | -q nqueries | -s packetsize | -w timeout ] * ...