SYStem.CPU HASWELLSERVER SYStem.Option.NoHyperThread OFF CORE.NUMber 56. SYStem.Mode StandBy Special Cases If the server board does not use a standard topology as described in section “Server Board Topologies”, the first two steps of the setup routine must be adapted: ...
Default mode, no debugging. TRACE32 loads the process with the selected command line. Process is stopped.SYStem.Option.IMASKASMDisable interrupts while single steppingFormat:SYStem.Option.IMASKASM [ON | OFF]Default: OFF. If enabled, the interrupt mask bits of the CPU will be set during assemble...
CPU SYStem.CPU CortexA76 //设置CPU型号 JTAG SYStem.JtagClock 8MHz //设置JTAG频率,这个会影响trace32运行的速率 CTI 等寄存器基地址 SYStem.CONFIG.COREDEBUG.Base DAP:0x_xxxx_xxxx SYStem.CONFIG.CTI.Base DAP:0x_xxxx_xxxx 启动系统并停住 SYStem.Up SYStem.Attach 数据load data.load.Binary H:/linux...
(without and with debug cable connected) • Check if VREF-DEBUG not properly connected to the JTAG connector • Check if the debug connector pins are correctly connected 17/9/2019 4 / 46 Debug Port Fail • Possible causes: • Core kept in reset, has no clock, has no power, ...
TRACE32 enables simultaneous debug of the multiple CPUs in a design with ‘mixed mode’ trace streams. Users can view the interleaved results in a single trace window, with a system-level timestamp to help align the streams. Extended trigger logic enables cross-triggering between the CPU trace...
Lauterbach黑芯调试器TRACE32在线帮助说明书 Blackfin Debugger Release 09.2023 MANUAL
TRACE32 PowerView用户手册说明书
debug symbols of process "sieve" Data.LOAD.Elf sieve /NoCODE /NoClear ©1989-2024 Lauterbach TRACE32 as GDB Front-End | 12 Typical Start-up Script for the Multi-Process Mode ; Reset all commands RESet ; Clear all TRACE32 PowerView windows WinCLEAR ; Select the target CPU SYStem.CPU ...
process threads Linux kernel modules drivers Ethernet or USB TRACE32 Powerview PowerDebug JTAG debugger JTAG CPU uboot xloader TRACE32: the most complete tool for embedded linux debugging ▪ 1/10/2014 ▪ www.lauterbach.com ▪ 33 / 58 ▪ What we mean by «run-mode debugging» ?
In the following example, the monitor commands are used to initiate the communication between TRACE32 and the target. For more details please see Monitor Commands. (gdb) target extended-remote 127.0.0.1:30000 Remote debugging using 127.0.0.1:30000 (gdb) monitor B::SYStem.CPU CortexA9 (gdb) ...