TPS7H2221-SEP 1.6-V to 5.5-V, 1.25 A, load switch in small plastic package TPS7H2221-SEP Key features • Space Enhanced Plastic (-SEP): Controlled baseline, producttraceability, gold bond wire, Ni-Pd-Au lead finish, enhanced moldcompound for low outgassing.• On Resistance (RON) of ...
TPS7H2221-SEP 器件是一款压摆率可控的小型单通道负载开关。此器件包含一个可在 1.6V 至 5.5V 输入电压范围内运行的 N 沟道 MOSFET,并且支持 1.25A 的最大持续电流。 开关导通状态由数字输入控制,此输入可与低压控制信号直接连接。首次加电时,此器件使用智能下拉电阻来保持 ON 引脚不悬空,直到系统定序完成。按计...
TI 的 TPS7H2221-SEP 為 耐輻射 1.6-V 至 5.5-V 輸入 1.25-A 負載開關。尋找參數、訂購和品質資訊
The results demonstrated that the TPS7H2221-SEP is single-event latch-up (SEL), single-event burnout (SEB), and single-event gate rupture (SEGR) -free up to 46.8 MeV·cm2/mg, at T = 125°C and T = 25°C, respectively, and across the full electrical specifications. Single event ...
www.ti.com Table of Contents Radiation Report TPS7H2221-SEP Neutron Displacement Damage (NDD) Characterization ABSTRACT This report presents the effect of neutron displacement damage (NDD) on the TPS7H2221-SEP device. The results show that all devices were fully functional and within production ...
1 Introduction The TPS7H2221-SEP device is a small, single channel load switch with controlled slew rate. The device contains an N-channel MOSFET that can operate over an input voltage range of 1.6 V to 5.5 V and can support a maximum continuous current of 1.25 A. The switch ON state ...
TPS7H2221EVM — TPS7H2221 evaluation module for 1.6-V to 5.5-V input, 1.25-A load switch The TPS7H2221 evaluation module (EVM) demonstrates parallel operation of the TPS7H2221-SEP load switch. The EVM allows the parallel circuit to be separated into two independent single-device circuits ...
www.ti.com Radiation Report TPS7H2221-SEP Total Ionizing Dose (TID) Table of Contents ABSTRACT This report discusses the results of the total-ionizing dose (TID) testing for the Texas Instruments TPS7H2221- SEP, Radiation Tolerant 5.5-V, 1.25-A Load Switch. The study was done to determine...