The TPM is ready for use, with reduced functionality If you’re faced with theTPM reduced functionalityissue, you can work around this issue for new deployments until a new version of MDT is available – add the command below to the ZTIBDE.wsf script at the start of the “Function Main”...
重新启动计算机。 注意: 在重启计算机前,保存所有用户会话中的所有未保存的工作,以免数据丢失。 11 启动tpm.msc ,然后单击 Prepare the TPM...。 12 等待Windows 重新准备 TPM(使用 Windows 10 安全措施)。重新准备完成后,tpm.msc 中的状态字段显示 The TPM is ready for use。 确认制造商版...
NoteIf TPM.msc reports that compatible TPM cannot be found or that TPM is in reduced functionality mode, restart Windows. After the restart, run TPM.msc again to verify that the state of TPM is "Ready for use." Shut down Windows to turn off the Surface Pro 3. Press and hold the Pow...
When running TPM.msc once OSD is complete the TPM module status "The TPM maintenance task is still running. Please wait a few minutes and refresh the page to see the updated status." After a while : The TPM is ready for use, with reduced functionality. Information Flags: 0x900 The TPM ...
The TPM is ready for use, with reduced functionality. Information Flags: 0x900 The TPM owner authorization is not properly stored in the registry. Windows's registry information about the TPM's Storage Root Key does not match the TPM Storage Root Key or is missing. ...
Indicates whether the TPM is ready for use. This method is only accessible by local administrators. Syntax C++ uint32IsReady( [out] BOOL IsReady ); Parameters IsReady[out] Set toTRUEif the TPM and system are fully provisioned for TPM use. ...
Step9: Run "tpm.msc" ---> The TPM is ready for use.Step10: Reboot system and Boot to "EFI Shell"Step11: Unzip "TPM2ProvfilesCBnT-20230302.zip" to USB and Install to systemStep12: Run command ---> Result : Empty FailedStep13: Reboot system and Boot to ...
For troubleshooting information, see Troubleshooting System Fundamentals Testing.If this test fails but the other TPM HCK tests pass, the TPM was not cleared before the operating system was reinstalled. If the TPM was not cleared, the status of the TPM will be The TPM is ready for use, with...
Confirm that NoPPIClear is set to true.This test has no additional test parameters.If BitLocker is enabled on the test machine, it should be disabled before running this test. If the TPM status is “The TPM is ready for use, with reduced functionality” you must ‘Clear the TPM’ and ...
System Event Viewer shows me "The TPM was successfully provisioned and is now ready for use". But when I look at the TPM.MSC is continues to display as STATUS: The TPM is not ready for use. And GET-TPM shows me: I've spent hours on the web researching and I'm out of ideas and...