Your toilet keeps running for one of two reasons: Water is leaking from the tank into the bowl. The fill tube is refilling too much water into the tank and causing the toilet overflow tube to activate. You should be able to stop either problem quickly by adjusting the flapper, float, or...
When your toilet keeps running water or is constantly running, we must first find out if you have a fill valve issue or a flapper/flush valve issue. Step 1– If you have shut off the water supply line, then turn on water and look inside the tank. Determine if the water level is ris...
Meanwhile, gravity forces the water and waste in the bowl through the hole in the bottom. It overflows the trapway, creating a siphon that sucks everything out of the bowl. Air rushes into the trapway, filling the space where the water was and cutting off the suction. Finally, as thew...
When water seeps under the flapper or canister and empties the tank, the fill valve keeps running in an attempt to get the water to the preset level, and if the leak is a slow one, the valve will cycle on intermittently, which is the not-so-mysterious cause of phantom flushing. The l...
the fill valve is also sending water down the overflow tube of the flush valve to refill the bowl. The overflow tube is why you don't get a flooded bathroom if something goes wrong with your fill valve, since any excess water in the tank will go down the overflow, into the toilet bow...
The overflow tube determines how high the water can rise. Moving the overflow tube down is more complex than these other tips and will likely require a plumber. Perform Occasional Empty Flushes Empty flushes can improve flushing in a low-flow toilet. It may seem that flushing an empty toilet...
The clip attaches to the back of the tank and keeps the 1/4" refill tube pointed towards and into the overflow tube of the tilt valve. The 1/4" refill tube must not be attached directly into the overflow tube. There must be an air break between the refill tube and the overflow tube...
If the flapper isn't the issue, the fill valve is the other likely culprit. The tube in your toilet tank is the overflow tube. If the float is adjusted properly, the water level should stop about 1 inch below the top of that tube. You can adjust the float if the water level isn'...
it will squeeze the taper into the adjoining pipe, creating a tight seal. We checked our work by running some water. When that looked good we filled the basin up to the overflow. Draining the full basin is a good test since this is the maximum amount that the drain will take at once...