Here's some resources and videos for Tinkercad users who want to make the move to Fusion 360: https://blog.tinkercad.com/level-up-from-tinkercad-to-fusion-360 “https://damassets.autodesk.net/content/dam/autodesk/logos/autodesk-logo-primary-rgb-black-small_forum.png” Reply Report ...
In order to add this shape to our design this way, we need to lift the shape off the workplane. To do that, click and hold the black cone hovering above the shape. Now move the cursor upwards while this cone is selected and the shape will begin to raise. TinkerCAD provides a lot o...
4. Drag a move block underneath it and change the "x" to 10 and the "z" to 20. 5. Insert a "Create Group" block underneath the move block, and then a Pause block after that. 6. Drag a "Delete Object" block from the Modify column and then drag "Degenerate Hyperbola" into the ...
Of course, the object is still too high. Just as we did with the box before, we can click on the little white cube on the top of the rounded roof and decrease its height to 3mm. Now that looks much better, doesn’t it? But we still need to move the objects into the right posit...
Location: The black cone shape above the shape allows you to move the object above and below the work plane. This is helpful when trying to add shapes to other shapes. Step 4: Simple Design Using Geometric Shapes and Holes Holes can be used to cut through shapes or can act as a way...
Move the duplicated holes until the large hole of the duplicate is exactly in the same place of the original large hole. Keep the duplicated shapes selected. Now, press again CTRL+D to duplicate. The new duplicated must appear on the other side of the cylinder, as it has turned 120°, ...
Tinkercad Math - Place Value to the Thousandths: This lesson is designed to allow grade 5 students the opportunity to apply their knowledge of place value to the thousandths to create a three-dimensional object. Students will learn the X, Y, and Z axes o
Use the plane tool to create a plane on top of the saucer. Center a cylindrical hole, and expand it so that only the edge of the top dome remains. Move it into the body of the object and then use the combine tool to cut away a cup for your plant. ...
(back). Position the rectangle so that one end reaches the back of the Model A, while the other side comes up about half way from reaching the front end (refer to photo). To elaborate, the rectangle should move past the door and come up about halfway to the front. For the roofs,...
Next we are going to want to duplicate the shape we just made ( search "how to duplicate object tinkercad" if you have trouble). Now lets select hole for this new shape and move it up a few mm. We can make the dimensions slightly smaller to make it the right kind of hole. **...