As regards the effect of temperature, the CMC values decreased with the temperature from 25 °C to 50 °C. Ellouze et al. (2021) found that the CMC of bovine β-CN decreased from around 0.5 wt% at 4 °C (pH 2.6) to 0.1 wt% at 24 °C, which was consistent with our study (...
However, little is known about the direct contribution of these inter- and intramolecular interactions on loss of solubility and protein digestibility. Low temperature (60 °C) and high temperature (130 °C) dry heating of cow's milk protein in the presence of lactose was applied after which ...
Effect of die temperature on the morphology of microcellular foams[J] . XiangminHan,Kurt W.Koelling,David L.Tomasko,L. JamesLee.Polym Eng Sci . 2004 (6)Han X.M., Kurt W., and Koelling D., Effect of Die Temperature on the Morphology of Microcellular Foams. Polym. Eng. Sci., 43 (...
Most numerical simulation studies have focused on the effect of homogenous wettability on fluid flow dynamics; however, most rocks display spatially heterogeneous wettability. Therefore, we have used direct numerical simulations (DNS) to investigate wett
Changing the scale or mixing conditions in a crystallizer can directly impact the kinetics of the crystallization process and the final crystal size. Heat and mass transfer effects are important to consider for cooling and anti-solvent systems respectively, where temperature or concentration gradi...
The results indicate that, after the first 0.5 h of thermal treatment, the surface charge was drastically reduced and that increasing the treatment time to 2.5–20.5 h, had no further effect on the surface charge. Due to the high temperature, rather low pH and long treatment times, it is ...
Before analysis, the debarked stems were dissected again with razor blades and thermal analysis of the stems was carried out on a Discovery DSC using Tzero hermetic aluminum pans (TA instrument). Around 5–10 mg of sample was cooled from room temperature to −30 °C following the sequence ...
Moreover, the effects of water as the nonsolvent additive, chemical composition of the bore solution, dope solution flow rate, air gap, coagulation bath temperature, and tensile ratio (take-up speed) were investigated. The addition of 3% wt. water as the nonsolvent additive into the dope ...
bile acid-based microcapsules containing metformin are affected by temperature; hence, their shelf life is likely to be affected by storage temperature, all of which have a direct impact on drug release and stability profiles. Keywords: microencapsulation;diabetes mellitus;bile acids;Eudragit;...
In part 1 of this study [1], the solution chemistries associated with high-temperature pressure oxidation of chalcopyrite in process water of various compositions under batch conditions were described and compared. More specifically, the effects of chloride ions in the process water upon the system ...