Jang, H. D,Jeong, J.The effects of temperature onparticle size in the gas-phase production of TiO2. Aerosol Science and Technology . 2001H.D. Jang, J. Jeong, The effect of temperature on particle size in the gas-phase production of TiO2, Aerosol Sci. Technol. 25 (1995) 553....
The effect of temperature on the growth of ultradispersed diamonds at a detonation front 来自 Semantic Scholar 喜欢 0 阅读量: 16 作者:VF Anisichkin,DS Dolgushin,EA Petrov 摘要: Experimental data verify that particles of ultradispersed diamond produced during the detonative decomposition of an ...
Liu, "The Effect of Melting Temperature and Time on the TiC Particles," J. Alloys Compd., 484 (2009), 95-101.K. Jiang , X. Liu : The effect of melting temperature and time on the TiC particles , Journal of Alloys and Compounds 484 ( 2009 ), pp. 95 – 101 DOI:...
Samples were incubated in the dark to limit any effect light might have on viral decay. A single humidity set point (50% relative humidity) was maintained for each of three separate temperature experiments (20 °C, 30 °C, 40 °C). For the 20 °C and 30 °C temperature experiments, ...
In this study, the effects of the temperature, oxygen content in the gas stream and carbon content in ash particles on PCDD/Fs formation on the fly ash surface were investigated. The optimum temperatures for dioxin formation were found at 350°C for boiler ash, 300°C for cyclone ash and ...
As well as experimentally determining the effect of thickness of a TPU coating on erosive wear, N. Zhang et al. (2013) [6] theoretically modelled the effect of temperature on the erosion resistance of TPUs at four temperatures between −20 °C and 100 °C. This research predicted that ...
The Effect of Pre-Oxidation Treatment on the High-Temperature Oxidation of Co–Re–Cr Model Alloys at Laboratory Air The aim of a pre-oxidation treatment at low oxygen partial pressure is to promote the formation of a Cr 2 O 3 (or Al 2 O 3 ) scale in such a way that the ... B...
The effect of temperature on the dynamic parameters of silty clay in a seasonally frozen region was assessed using a GDS dynamic triaxial test system. The strength parameters, dynamic elastic modulus, damping ratio, and other dynamic parameters of the soil samples were analyzed under different temper...
Therefore, the effect of deformation temperature on the hardness of as-deformed samples was very limited. The annealing of samples at 823 K/6 h induced a chemical reaction between NiO-particles and surrounding aluminum matrix. As a result, the development of very fine aluminum oxide and Al3Ni...
At temperatures greater than 85 °C, negative wear was maintained, with the coefficient of friction dropping monotonically with increasing temperature up to 450 °C. It is proposed that the changes in wear rate and friction coefficient were due to changes in the way that the oxide particles ...