2.1.1288 Part 4 Section 5.1.4.1.9, dk1 (Dark 1) 2.1.1289 Part 4 Section 5.1.4.1.10, dk2 (Dark 2) 2.1.1290 Part 4 Section 5.1.4.1.15, folHlink (Followed Hyperlink) 2.1.1291 Part 4 Section 5.1.4.1.17, fontRef (Font Reference) 2.1.1292 Part 4 Section 5.1.4.1.19, hlink...
3-point bend is considered a “pure” mode of deformation since clamping effects are eliminated. The 50 and 20 mm clamps on the Q800 utilize unique low-friction, roller bearing supports that improve accuracy. Shear Sandwich In this mode, two equal-size pieces of the same material are ...
while test $# -gt 0 ; do case $1 in --time-stamp | --time* | -t ) echo "$timestamp" ; exit ;; --version | -v ) echo "$version" ; exit ;; --help | --h* | -h ) echo "$usage"; exit ;; -- ) # Stop option processing shift; break ;; - ) # ...
Therefore, it is difficult to quantitatively characterize the stress and strain values point by point that are around the notch tip; instead, the nominal stress and strain values of the bulk tensile sample are used. It is determined that δ and σ0.2 of the notched 0.05Ce sample was ...
(medium Al/Ti ratio), solidification with γ phase formation is estimated to begin at 1355 °C, 1349 °C, and 1341 °C, respectively, whereas MC carbides are expected to precipitate at 1294 °C, 1288 °C, and 1267 °C. Additionally, superalloys A3 and A4 share the same liquidus ...
(PDF# 44-1288) phase related diffraction peaks at the bottom ofFigure 1a. Only the Ta-related peaks were detected in the coating samples: while the monolayer coating consisted of α-Ta (PDF# 04-0788) phase, the outermost Ta layer of the multilayer coatings mainly consisted of α-Ta with...