# Restart network (through NetworkManager if running) if service NetworkManager status 2>&1 | grep -q running; then service NetworkManager restart else service network restart fi Stdout from the command: Restarting network (via systemctl): [FAILED] Stderr from the command: Job for network.service...
An older version of Linux is likely responsible for the “Systemctl: command not found” error, as it does not support the systemctl command, which results in the PC displaying the error instead of performing the correct command. But, in case you have a new device and still get the same...
不确定这是否是原因，但可能是SELinux造成的。可能它阻止了连接或权限。稍后让它工作：
Job for network.service failed because the control process exited with error code 虚拟机设置静态IP,恢复快照后,重启网卡systemctl restart network报错; 执行以下三条命令即可: systemctl stop NetworkManager systemctl disable NetworkManager systemctl restart network... ...
Then to check whether it is running without any errors, you can type the command sudo service bluetooth status If you want to restart or stop a service, you can use the commands“service [service-name] restart”and “service [service-name] stop”respectively. ...
Using ip Command Another method to restart the network is using the ip command with the interface name. The name of the interface can be found by using theipcommand, with thelink(Network device) andshowoptions. ip linkshow Note the interface name, it is interface number 5 (wlx74ea3) whi...
Hello, When I try to systemctl restart network the following error pops up Job for network.service failed because the control process exited with error...
重启服务:systemctl restart vsftpd.service 显示服务的状态:systemctl status vsftpd.service 在开机时启用服务:systemctl enable vsftpd.service 在开机时禁用服务:systemctl disable vsftpd.service 查看服务是否开机启动:systemctl is-enabled vsftpd.service
systemctl restart network.service 显示一个服务(无论运行与否)的状态: systemctl status network.service 在开机时启用一个服务: systemctl enable network.service 在开机时禁用一个服务: systemctl disable network.service 查看服务开机是否启动:systemctl is-enabled network.service;echo $? 或者是chkconfig 使用...
Restart=on-failure ExecStart=/usr/lib/node_modules/pm2/bin/pm2 resurrect ExecReload=/usr/lib/node_modules/pm2/bin/pm2 reload all ExecStop=/usr/lib/node_modules/pm2/bin/pm2 kill [Install] WantedBy=multi-user.target Target path /etc/systemd/system/pm2-carles.service Command list [ 'system...