There are two main kinds of airbag sensor. The first one is known as the mass-type sensor which is often placed in the car’s front part to measure a noticeable impact. Most of the time, it has two sensors. First is placed inside the engine and the other one is mounted in the pas...
Once you are done finding the sensor, take off the negative battery саblе to keep the process safe.2. Install the new sensorTake off the old sensor by unscrewing it and get ready to screw a new one. Read out the manual of your car for any specific instructions no matter if you ...
Depending on the type ofbad PCM symptoms, you may have torepair or replace the unit. Replacing is simple, and involves nothing more than swapping boxes. If you are doing it at home, remember to disconnect the battery before removing the old PCM and through the installation of the new one....
If a sensor or part is reading bad, be sure to visually inspect the wires coming out of that part, and verify conductivity with a multimeter. If electricity is reaching a certain spot in the wire, but not all the way to the sensor, that wire should be replaced. Conclusion Tracking down...
When I started my car after recharging the battery, “CHECK ENGINE” light came on. The light went off after I turned on and off the car a few times but white smoke came out from both exhaust pipes. Little chilly and wet weather here in Seattle but more white smoke came out when I ...
You can also attempt to bypass it by restarting your car or removing one of the battery terminals to reset the system. iStock.com/Giselleflissak If you decide to try the latter option, wait five minutes after disconnecting the battery, then use an OBD scanner to try to clear any faults...