This paper proposes an algorithm adaptive based on multi-loop switching which can output the results of two navigation systems analysis and identification, and adaptive switching loop based on the results, thus completing the coupling approach to select the appropriate combination of navigation, if ...
The system uses hash algorithm to compute load sharing modes based on the MPLS labels, source and destination port numbers, IP addresses, MAC addresses, ingress ports, or any combination. Also, you can specify traffic to be load shared by packet. Configuration restrictions and guidelines When ...
The STP algorithm does not determine that a topology changes until the timer expires, delaying network convergence. The STP algorithm requires the root bridge to send configuration BPDUs after the network topology becomes stable, with other devices processing and spreading the configuration BPDUs throug...
2)Enter the interface configuration mode of the suspicious ports, and then run the loopback-detection command to enable loopback detection on these ports. If a loop is detected on these ports, the switch will send a trap and generate an entry on the log file. 21 In Which Scenario Can ...
on Specified Interfaces 111 Enabling BPDU Filtering Globally 112 Enabling BPDU Filtering on Specified Interfaces 113 Enabling Loop Guard Globally 114 Enabling Loop Guard or Root Guard on Specified Interfaces 115 Verifying the STP Extension Configuration 116 Troubleshooting Loop Detection Error Message 116 ...
the input of any of nodes 102, 103-1 to 103-n to the output of any one other selected node in the system. The pattern of such connections is determined by common control circuit 101 in response to the current loop conditions and to the algorithm programmed into common control circuit 101...
authentication-algorithm sha2-256 —配置完整性算法(默认为sha1) encryption-algorithm aes-cbc-256 ---配置加密算法(默认为des-cbc) dh group 14 —配置dh组(默认为dh组1-768bit) sa duration 3600 ---配置sa生命周期(默认为86400s) display ike proposal 10 ike peer shanghai v1 —创建ike对等体,选...
As you have seen, the transparent bridging algorithm floods unknown and broadcast frames out of all the ports that are in the same VLAN as the received frame. This causes a potential problem. If the network devices that run this algorithm are connected together in a physical loop, flooded fra...
The traffic would be forwarded to R2, but since the route is not part of the table on R2, it would use its default route to send the traffic right back to R1. And again we have a routing loop. One solution for this problem would be to install null routes on R2 in order to ...