Please configure the following configuration in the user interface view. Table 2-3 sets the number of terminal screen lines, operations, commands Sets the number of rows displayed on a screen at the user terminal Screen-length screen-length ...
Step 5 copy running-config startup-config 保存 Multilayer Switch Switch Virtual Interface (SVI) Configuration Example and Explanation 2. Port 以太网端口有三种链路类型:access、trunk、hybird Access类型端口:只能属于1个VLAN,一般用于连接计算机端口; Trunk类型端口:可以允许多个VLAN通过,可以接收和发送多个VLAN ...
ACL Configuration Commands acl (system view) acl ipv6 acl ip-pool acl port-pool eq/gt/lt/range (ACL port pool view) ip address (ACL address pool view) description display acl display acl hardware statistics display acl hardware statistics ipv6 ...
Verify the configuration. Attackers fail to log in to the SSH server using the default listening port number 22. <client002> stelnet 10.1.1.1 Trying 10.1.1.1 ... Press CTRL+K to abort Error: Failed to connect to the remote host. Run the display ssh server status commands. You can see...
Switch#configure terminalEnter configuration commands, one per line. End with CNTL/Z. Switch(config)#no boot system flash bootflash:cat4000-is-mz.121-8a.Ew1Switch(config)#boot system flash bootflash:cat4000-is-mz.121-11b.EWSwitch(config)#config-register 0x2102Switch(config)#end00:01:31: ...
An obvious but sometimes overlooked cause of port connectivity failure is an incorrect configuration on the switch. If a port has a solid orange light, this means the software inside the switch shut down the port, either by way of the user interface or by internal processes. ...
Configuration in /etc/network/interfaces auto swp1iface swp1 link-autoneg off link-speed 25000 link-fec rs Tomahawk predates 802.3by and does not support RS FEC on a 25G port or subport; however it does support Base-R FEC. The configuration for Base-R FEC is as ...
¡ If the ACL is configured correctly, go to step 3. 3. If the issue persists, contact H3C Support. Related commands This section lists the commands that you might use for troubleshooting ACLs. Command Description display acl Displays configuration and ma...
This is done by running the same Stop-DatabaseAvailabilityGroup command with the ConfigurationOnly parameter using the same ActiveDirectorySite parameter and specifying the name of the Active Directory site in the failed primary datacenter. The purpose of this step is to inform the servers in the ...
The databases can now be activated. Depending on the specific configuration used by the organization, this may not be automatic. If the servers in the standby datacenter have an activation blocked setting, the system won't do an automatic failover from the primary datacenter to the standby datac...