• Never touch a blank contact on the DC output right after usage of the device, because between DC- and DC+ there is potential against ground (PE) which discharges more or less slowly or not at all! • The equipment must only be used as intended • The equipment is only approved...
5.1.2 Power-up Conditions When the power supply is turned on, VCC rises continuously from VSS to VCC. During this time, the Chip Select (/CS) line is not allowed to float but should follow the VCC voltage, it is therefore recommended to connect the /CS line to VCC via a suitable ...
USB 3.0 sticks also work, but not from all manufacturers. All supported files must be held in a designated folder in the root path of the USB drive in order to be found. This folder must be named HMI_FILES, such that a PC would recognise the path G:\HMI_FILES if the drive were ...
开关电源设计全过程(Switching power supply design process).doc,开关电源设计全过程(Switching power supply design process) I. Introduction The switching power supply is the use of modern electronic technology, the control switch turn-on and turn off tim
−Cγ>0, the stable strategy of the three parties is (non-cooperation, non-cooperation, cooperation); that is, the manufacturer and seller choose not to participate in the green collaborative innovation behavior strategy, while the consumer chooses the green collaborative innovation VCC behavior ...
They found that a market orientation has a substantial positive effect on the profitability of both commodity products businesses and non-commodity businesses. Noble et al. [50] found that competitor orientation has a significantly positive impact on performance. According to Kohli and Jaworski [60]...
00.0000 i have attempted to identify alameda's locked stake based on the unlock dates and lockup size reported on solana.com . these tagged withdraw authorities are the best match i have found, but i can't guarantee they are correct. previous unlocks 348,991,141 unlocked to date 6 ...
UHigh > 4 V No alarm = LOW, ULow <1 V Constant voltage 15 STATUS*** DO regulation active DC output CV = LOW, ULow <1 V CC/CP = HIGH, UHigh >4 V On = LOW, ULow <1 V Off = HIGH, UHigh >4 V Quasi open collector with pull-up against Vcc ** With 5 V on the pin ma...