I have done my digital ASIC implementaiton on SoC Encounter and now I want to RUN LVS,PEX on Calibre. When I run LVS,I get an ERROR: Supply error detected. ABORT ON SUPPLY ERROR is specified - aborting. *** Calibre finished with Exit Code: 4 *** What's the problem?IC...
老师参与 LVS检查时ERROR: Supply error detected. ABORT ON SUPPLY ERROR is specified - aborting. 关注 回复 分享| 赞(0) | 举报 所有回复(7) SEU-微9班-无-236572-魏玉洁 请问有人解决这个问题了吗? 2023-3-14 评论(0) 赞(0) | 举报 杨阳ykt1481972511618 Calibre finished with Exit Code...
[ 158.299054] sec-battery battery.98: sec_bat_time_management: Undefine Battery Status [ 186.679895] xhci-hcd xhci-hcd: Stopped the command ring failed, maybe the host is dead [ 186.710900] xhci-hcd xhci-hcd: Abort command ring failed No errors detected Advertisement Advertisement...
When input errors are detected, they are described to the user in text, including identifying the item where the error occurred 3.3.2 Labels or Instructions (Level A) Supports The product was tested for: Labels or instructions are provided when the product requires user input 3.3.3 Error Sug...
Similar constraints are needed for the Main Ring and Tevatron antiproton abort systems. A unique feature of this design is the high voltage, high current diode assembly used to clip the recharge of the capacitor bank. This allows the current to decay slowly with the L/R time constant of ...
If a fault is detected, the OPEN bit (bit 0) in the temperature result register is set to '1' and the rest of the register bits should be ignored. When not using the remote sensor with the TMP512/13, the DXP and DXN inputs must be connected together to prevent meaningless fault ...
I also ran iozone on one partition to stress test it a bit, and no disconnection or anything. I did have some related error messages at boot time however. I don’t know if those are normal: [ 35.853471] sd 0:0:0:0: tag#0 uas_eh_abort_handler 0 uas-tag 1 inflight: CMD IN [...
Bit 2 (abort) This bit is set if the command has been aborted because of a card status condition (Not Ready, Write Fault, etc.) or when an invalid command has been issued. Bit 1 This bit is '0'. Bit 0 (AMNF) This bit is set when there is a general error. Table 41. Error ...
An on-chip Program/Erase Controller simplifies the process of programming or erasing the memory by taking care of all of the special operations that are required to update the memory contents. The end of a program or erase operation can be detected and any error conditions identified. The ...
When input errors are detected, they are described to the user in text, including identifying the item where the error occurred 3.3.2 Labels or Instructions (Level A) Supports The product was tested for: Labels or instructions are provided when the product requires user input 3.3.3 Error Sug...