It worked well until this morning when it displayed "Error in initializing ST-Link device, Reason (4) No device found on target" at the time I was burning an image to it through the ST-link on stm32CubeIDE. Then I used stm32CubeProgrammer to connect the board with st-link, it ...
Reason: No device found on target. Currently I have 2 workarounds: set Boot0 to GND, push reset and then start the programming, wait for finished download to the device, set Boot0 pin to 3V3 (via 100k resistor) again, press reset, now the new program is running. Use ...
STM32F103有3个通用同步异步收发器（Universal synchronous asynchronous receiver transmitter，USART），2个通...
and it still locked up in the same way - CR1=0xf7, sys_work_q is stuck on the k_sem_take(&data->device_sync_sem, ...), but device_sync_sem has no waiters listed. diff --git drivers/i2c/i2c_ll_stm32_v2.c drivers/i2c/i2c_ll_stm32_v2.c index a685ebebeb..bcc1af1bc6 ...
A first possibility to flash the non-removable storage is to use a removable storage device, boot a Linux system on the device, and use it to flash the non-removable storage. This can definitely be a possible option in some situations, but it is not always possible (if there’s no remo...
On MacBook Pro M2 (Mac OS 13.3.1) running PlatformIO IDE v3.3.1 in VS Code 1.82.2 Main error: dyld[2890]: Library not loaded: /usr/local/opt/libusb/lib/libusb-1.0.0.dylib Uploading from Arduino IDE works fine. The device is actually at /...
我也有同样的问题，我设法解决了它。原来，我的杀毒软件(avast)阻止调试器启动，方法是将文件ST_LINK_...
The J-Link expects that these registers are written by J-Link only andnotby the target application! Device security On connect, the device security is checked. If security is set (and recoverable) the user is asked if they want security to be lifted. If the user agrees, security is lifte...
(note: I had to right-click the link and hit “save target as…” for some reason, instead of just clicking the link to start the download.) This installer will also ask you some questions typical of an installer like language, an MIT license, shortcuts, ins...
1.打开新建工程Device目录下RTE_Device.h文件,查找RTE_ETH宏,修改成1。 2.因为我们要使用RMII接口,所以确保RTE_Device.h下,宏RTE_ETH_MII为0,宏RTE_ETH_RMII为1,并查看一下GPIO的配置,默认如下: 你没修改其他配置的话,请按照上图GPIO配置接好stm32和DP83848。 使用特权 评论回复 赏 点赞木木...