在正常的程序里面,我添加了MB85RS16(spi flash)这个外设驱动代码后,使用ST-Link II下载就出现cannot halt the core。 这个现象之前出现过1次,但是解决办法忘记了,又重新搜索了一下解决办法,在这里记录一下,作备忘录,同时也分享给大家。 解决办法1:按下复位键一松手,马上点MDK上下载按扭就可以正常下载了(已验证...
解决办法:用Jlink调试器,下载前勾选上“Erase Full chip”,将整个chip擦除,下一次程序,这时再用ST Link 调试器就正常了。 后来我仔细回想了一下,应该是目标device选的不对(主型号是对的,但flash容量选的不太一样)造成了“can't halt the core”这个错误。
显示can't halt the core。在这3秒内，将ARM芯片上的复位管脚拉低后放开，便能成功擦除芯片程序。
仿真器用的是万利的ST-Link II，之前用MDK4，下载不了程序，一点仿真后出现can't halt the core。
14:53:41 :Can't halt the core' But, when running on Hot Plug mode, a connection is made available. What's interesting is that the Device ID is not recognized, nor is the Device Family. Although the FLASH memory cannot be erased due to a Read Out Protection, this read out prot...
3.7 MCU core functions The Core panel dialog box shown in Figure 21, displays the Arm® Cortex® -M3 core register values. It also allows the user to carry out the following actions on the MCU, using the buttons on the right: • Run: Run the core. • Halt: Halt the core. ...
printf("Failed to halt the core\n"); gotoon_error; } if(stlink_status(sl)) { printf("Failed to get Core's status\n"); gotoon_error; } if(o.cmd== FLASH_CMD_WRITE)/*write*/ { size_tsize =0; if(o.format== FLASH_FORMAT_IHEX) { ...
Programmer/board type: stlink v3 mini Operating system and version: Windows Stlink tools version : 1.6.1 Stlink commandline tool name: st-flash Target chip (and board if applicable): STM32G031 Commandline-Output: st-flash --connect-under...
the STM32 ST-LINK utility. When working with the STM32 ST-LINK utility, it is recommended to download the ST-LINK in- circuit debugger/programmer for STM8 and STM32 microcontrollers User manual (UM0627) or the ST-LINK/V2 in-circuit debugger/programmer for STM8 and STM32 User manual (...
. Select [Log All] and [Halt CPU Above Threshold] to halt the code execution automatically above a given threshold. AN5999 - Rev 2 page 31/59 AN5999 IAR Embedded Workbench IDE (from version V9.32.2) Figure 32. IAR Embedded Workbench IDE Power Log Set...