N Hold the bar nose up. N Use a screwdriver to turn the tensioning screw (1) clockwise until the chain fits snugly against the underside of the bar. N While still holding the bar nose up, tighten down the nut firmly. N Go to "Checking Chain Tension". A new chain has to be re...
: Insert the screw in the nut from the other side and tighten moderately – the elbow must still turn. 14 SR 340, SR 420 English / USA Mounting the extension tube Fitting the liquid hose 1 2 5 21 : Rotate the pleated hose (1) as far as stop. : Turn the control handle (2) so...
: Insert the screw (5) and tighten it down securely. : Go to "Tensioning the Rewind Spring". : Make a loop in the unwound starter rope and use it to turn the rope rotor six full revolutions counterclockwise. Hold the rotor steady – straighten the twisted rope – release the rotor –...
round the lug : Refit the rope rotor : Tension the rewind spring : Refit the fan housing and screw it into place If the spring has popped out of the spring housing: : Replace it, working anticlockwise from the outside inwards : The arrow on the tensioning nut (1) must point to "0"...
Arrows on the tie straps on the top of the bar must point toward the bar tip. 23 1 ► Point the guide bar tip away from the chain sprocket (1). ► Place the chain around the chain sprocket. ► Slide the guide bar over the collar screw (3) and pin (2). The head of the...
N Hold the bar nose up. N Use a screwdriver to turn the tensioning screw (1) clockwise until the chain fits snugly against the underside of the bar. N While still holding the bar nose up, tighten down the nuts firmly. N Go to "Checking Chain Tension". A new chain has to be re...
N Fit the chain – start at the bar nose. 1 N Remove and reverse tensioning gear (1) MS 171, MS 181, MS 181 C, MS 211, MS 211 C 27 English 2 Releasing the chain brake N Remove screw (2) 1 3 N Pull hand guard towards the front handle until it engages audibly – chain ...
N Hold the bar nose up. N Use a screwdriver to turn the tensioning screw (1) clockwise until the chain fits snugly against the underside of the bar. N While still holding the bar nose up, tighten down the nuts firmly. N Go to "Checking Chain Tension". A new chain has to be re...
English N Fit the guide bar over the studs (1) – the cutting edges on the top of the bar must point to the right. N Engage the peg of the tensioner slide in the locating hole (2) –- place the chain over sprocket (3) at the same time. N Turn the tensioning screw (4)...
N Hold the bar nose up. N Use a screwdriver to turn the tensioning screw (1) clockwise until the chain fits snugly against the underside of the bar. N While still holding the bar nose up, tighten down the nuts firmly. N Go to "Checking Chain Tension". A new chain has to be re...